twangy57
Responses from twangy57
| Dynaudio focus 360 zarf Yes,I have seen that,having a left and right volume would take the place of a balance I'am assuming. I think I would miss the tone controls as a lot of older stuff I listen to has to be eq'd just to make it tolerable. Thanks for the respon... | |
| Dynaudio focus 360 zarf Glad to hear you like your dynaudio's with the CJ pre and MF amp I should get my cj350 by the end of the week and will let you know my impressions after I get some listening time with it. I'am curious about the cj 17LS2 ,do you miss tone c... | |
| Dynaudio focus 360 knownothing I have no doubt that a good set of speaker cables would do wonders for the Dynaudio Focus 360's. I need to get the amp first and listen a bit to hear how that sounds before the next improvement. I have really been enjoying what I ... | |
| Dynaudio focus 360 goodlistening64 Yes,I have the p6 with the exact 2. I will look into a phono pre-amp once I decide if I ’am going to keep the Mac pre-amp or not. I have been listening to 75% streaming as I don’t have much vinyl that is in good condition. Thanks | |
| Dynaudio focus 360 gano I didn't know anything until about damping factors or amp output current,until I was schooled on it here. From what I have been told it was the focus floor standing speakers that like a lot of current. I think Musical Fidelity slipped thru... | |
| Dynaudio focus 360 jeffbij Thanks Jeff, I have been listening for a least a couple hours a day since getting these speakers and the tidal streaming. I have to agree I should at least get a standalone phono preamp, A lot of Rega users don't really like there M... | |
| Dynaudio focus 360 jeffbij I have received so much great information,and I have taken notes trying to put in a logical format to have a practical check list. Well I know its a little late for that. I have looked at lot of the suggestions for amps given,and most... | |
| Dynaudio focus 360 mrdecibel I know you are probably correct in saying a this amp will show how noisy a old Mac can be. I called Conrad Johnson just to make sure I could get this serviced down the road,and I was pleasantly surprised. Someone picked up the phone o... | |
| Dynaudio focus 360 gano I almost forgot to ask you about damping factor. Could you give me a example of what mine is or what it should be? My speakers are 4 ohm and the output impedance of the Adcom is rated down to 4 ohms,as far as the resistance of my cables I ... | |
| Dynaudio focus 360 mrdecibel I can see your point,. I always wondered why on even expensive guitar amp's they never seem to put anything better than a run of the mill IEC power cord. | |
| Dynaudio focus 360 goodlistening64 I’am glad you made that point about the impedance. Yes ,I believe you when you say the impedance mis-match is probably not really the main problem. I do know that when I replaced my Adcom pre with the Mac,I loved what it did to... | |
| Dynaudio focus 360 kennyc 1,836 posts 05-12-2025 at 05:21pm ...right combination of power and current. Agree you're on the right track- ample availability of current needed for high energy bass Yes,when I explained to the gentlemen at dynaudio that the vocal... | |
| Dynaudio focus 360 ronboco 902 posts 05-12-2025 at 07:45pm @twangy57 How about some good class d Monoblocks? I believe I looked into them and I couldn’t find any with input impedance of 100koms or greater,which is what macintosh recommends for my mx100 tube ... | |
| Dynaudio focus 360 Yes,but he has a expensive speaker habit .lol | |
| Dynaudio focus 360 gano thanks for the link. I have watched him before. I think he did a review on the dynaudio special forties. |