theaudiotweak
Responses from theaudiotweak
| Top resistors Jack,I did the same 2 years ago with a complete rebuild out of my mono bloc pair. The Vishays have tolerances that are much tighter than 1%.. Try building resistor bridges with the nude Vishays and install in your speakers..The result will be much... | |
| Capacitor log Mundorf Silver in Oil Bill,I have built power resistors using Mills 12 watts as the element. Drilled thru the center of a .875 brass rod coated and set the resistor with Cascade Audio V-Bloc and placed the Mills inside, had these cryo'd. The Vishay's sound better..of c... | |
| Capacitor log Mundorf Silver in Oil Years ago I rebuilt my set of Dunlavy speakers with Vishay metal film resistors. Their top of the line in the mid 90's. These made more difference than any single part swap I ever made..tears of joy came into my eyes the difference was so huge. Ca... | |
| Synergistic Red Fuse ... I read a year or so that lithium ion batteries charging time could be reduced by at least 25% with the addition of graphene to their charging posts. Another benefit was that this added material allowed for the battery to approach a near 100% full ... | |
| Synergistic Red Fuse ... Use a N52 magnet in place of the fuse or the jumper..$ 2.49 American. I use them everywhere..enter at your own risk. Tom | |
| Synergistic Red Fuse ... I have tried both thru out my system..doing one side at a time. The side without the magnets..well I had to move my chair almost in front of that speaker to capture the balance from both speakers. Made more difference on the ac side of things..may... | |
| Synergistic Red Fuse ... Easy to reference and mark the polarity. Its up to the listener to determine the chosen direction for best sonic results. Tom | |
| Synergistic Red Fuse ... My turntable has a fuse and I made a decision to replace it with a N52 magnet..I did so years ago ..2008 on my LP12..all mirrors and no smoke. The magnets cost $2.43 American and direction is obvious by nature. Freedom of your own choice to do so... | |
| Synergistic Red Fuse ... "Exactly why I use cryo treated N52 magnets"..Tom | |
| Do equipment stands have an impact on electronics? Shear wave energy was generated from the friction and vibration of the blades as they crossed and made contact. The hand holding the cutters dissapated the shear. Shear energy cannot be transmited thru air. Tom | |
| Do equipment stands have an impact on electronics? So when you cut your Mane did this result in less shear wave interference? Tom | |
| Do equipment stands have an impact on electronics? My patents are for the enhancement of musical instruments and their directional vibration transfer.. Tom | |
| Do equipment stands have an impact on electronics? Crown amps of the early 70s had 60db of negative feedback and no distortion.??vs a Marantz 8b that had over 1 % thd..but you could listen into it all nite long. Tom | |
| Do equipment stands have an impact on electronics? I have 2 patents have a new one under application and review.. and with an associate one being updated.You can reduce the distortion on vinyl with the removal of a polarity of shear..You have to understand how its there in the first place and conc... | |
| Do equipment stands have an impact on electronics? You are wrong none of what I own or use do I consider Isolated. That word is offensive and just dirt. Just the opposite everything is direct coupled to the floor so as to remove or reduce shear wave interference. I use the same direct coupled met... |