rlw3
Responses from rlw3
| Wilson Sophia III vs Sasha i am thinking about sophia 3s or 2s. i have a cj act 2.2, simaudi w7 amp(150/300/500w) and a sim supernova cd. room is panel treated 19x13x8 which opens up into a hall way and a small room on the other side of the hall. i worry about size/speaker ... | |
| find exact center of tonearm bearing The device arrived and i used it quickly and easily. it looks like a 90 degree prong that is about 3 inches long and a half an inch thick. a seperate piece of metal is attached above the prong dissecting the 90 degrees at 45 degrees. you simply pl... | |
| How to "break-in" new speakers?? USE A MONO CD if you are going to wire speakers out of phase and have them face each other as suggested above-You need exact same signal going to both speakers if you want as much noise cancellation as posible | |
| Suggestions for amping a pair of Revel Studio2s My room is 13 feet wide-is that wide enough for a studio 2 or 1? 30 ft length, open to hallway and 8 foot ceiling. also considering sophia 2 or watt pupp 7 | |
| What do I need to consider when buying amp and sub If your main speakers have ports then most likely the best intergration will be achieved if your sub is ported | |
| Has anyone actually bought a Zesto Phono preamp? Clio09thank you | |
| Sutherland 2020 vs Parasound jc 3 Sksos1,thank you for your reply.Did the jc3 change a lot during break in? the new jc3 with a handfull of hours on it sounded so thin and truncated that it would take a major amount of improvement to be satisfactory to me. The difference between th... | |
| Sutherland 2020 vs Parasound jc 3 Had a new jc3 in my house for 2 days sounded compressed and truncated-but it was new. Audiofreakgeek did your jc3 need some break in time. Please describe | |
| Has anyone actually bought a Zesto Phono preamp? Alexs or Clio09How wall does this phono preamp do rock or blues? My 2 previous tube phono stages had extremely good decay which served natural instruments but did not have the attack that properly portrays electric instruments. | |
| Anyone else using the VonSchweikert vr35 speakers? Thankful how are your 35's modified per your response on another thread? i have a pair powered by sim audio w7s, cj act 2.2 and a simaudio super nova cd. How were the 35s modified and with what results??? thanks ray | |
| Is there a 3g. anti-skate weight for Graham arms? I'm very late to the party... my graham 2.0 with 2.2 bearing cap gave me too much anti sskating as measured with a wallytool with a koetsu rosewood sig and the standard antiskate weight all the way up the shaft to minimize. Got a lighter weight fr... | |
| ARC PH7 upgrade curbfeeler what did you think about the sonics between the 2 versions of the ph7 besides the 430khz problembeing fixed? | |
| SDS speed control if your wooden/plastic motor spindle the belt touches is the wrong diameter the sds will be adjusted to a level it is not designed for and never settle down. this happened to me. vpi sent me a smaller diameter and cured problem | |
| Von Schweikert VR-33 i have owned vr 35s for 15 months. i think they may have kept improving during the 500-1000 hr mark. i have a wood rancher with a suspended floor and find placement close to walls to be boomy so i place them 44" x 33" into the room. If i had a con... | |
| Fosgate Signature Phono Preamp any thoughts of the differences between art audio's vinyl reference and the fosgate? or the art audio and any of the other fine phonos mentioned above?? thanks for your help |