rcreations
Responses from rcreations
| looking for preamp with built in tuner a pre/tuner that regretfully went down the road was a hafler 945. (200.range used)doesnt have a phono section but was a great low-cost pre with a very tight tuner. kurt | |
| low tech rubber tweaks whats the objective, other than a trip to the hardware store? i hate plumbing!! go 4 it!! | |
| Benz Ebony/ruby in VPI JMW12.5 arm, fluid damping only one way for your ears to know.....add the fluid and hear what they think. had the same thoughts when installing my PT-6. do i or dont i. decided that to swab the fluid back out was an easy task, and immediately liked the fluid installed. kurt | |
| good info source for front projector ??? check out full compass for some hefty discounts and closeouts. kurthttp://64.213.162.194/specials/categories/VI0020/index.fcml | |
| Jena Labs - Any experience? replaced my nordost silver shadow cable with a jena visionary 75 ohm which held its own and then some. also had a gemini digital cable that was a very solid digital cable. kurt | |
| Your Favorite, Most Outstanding Guitar Solo the funkadelics 'maggit brain'brian eno from here come the warm jets, robert fripp's solo on the track 'baby's on fire' amazing.... | |
| What's the oldest piece of gear in your system? using several fulton (FMI) products in my analog setup. tonearm, MC cartridge, and stepup tranny. fulton brown wire, and four Quatre (now Audire) amps in the homely theatre setup. periodically use boulevard tube mono's (50's?) in a second system. ... | |
| Budget Phono Preamp -- Under $250? a buddy of mine has some rather nice phono pre's, CJ EV 1 camelot dc powered but uses a rotel with great results. he swears by it.found one on this site. Rotel RQ970BX Phono Stage Preamps: Solid state > Item: 1072518949 i'm not involved with t... | |
| Noise Problem Conrad Johnson PV 12 tubes is my guess. my 12 is quiet to the point that i'm not aware its on. kurt | |
| Jazz in San Francisco take the BART (bay area rapid transit system) to the east bay. not a biggy. years ago was a club on university ave in berkeley, the matrix. had all the greats coming thru. kurt | |
| VPI MK-4 platter problem my mark III platter was not able to interchange with the stock jr well. think you'll need a mk 4 bearing cup. kurt | |
| I have dedicated lines, but why is this happening? ground your dedicated line to the box (fuse panel) instead of the buse bar. kurt | |
| How do you clean your speaker grills? locate an air compressor and blow from the inside out. might need to regulate the pressure to 60-80 psi. the dust leaves without any rubbing or washing it deeper into the fabric/fiber. kurt | |
| VPI HW-19 Jr. Upgrade sell the jr and buy a scout.i went with a mk III platter/bearing and like it well enough to not advance any further at this point. | |
| Favorite Movie Soundtrack dylan....pat garrett and billy the kid. |