pepler
Responses from pepler
| B&W DM70's - top end lacking Hello Gentlemen,I too own a pair of DM-70s I am powering mine with mine with McIntosh MC30s. The sound is amazing! When I first heard them the bass seemed overbearing, but after some investigation I found the mounting nuts to be lose. I tighten... | |
| MC suggestions for conrad-johnson Premier 15 What are other Premier 15 15/2 owners running for MC cartridges? | |
| MC suggestions for conrad-johnson Premier 15 Thank you Dover! I will look into the benz micro line. | |
| MC suggestions for conrad-johnson Premier 15 Hi MarK,Thanks for you response. I am going to look at modding my premier 15 something like the link below if I dont get any info here. I think there is too much gain with that setup. It seems it would have as much output as what I currently have ... | |
| Cj Premier 11A fuse I know this is an old thread but here is my 2c.KTK-1 for later productionBBS-1 for earlier productionKTK is 1/8" longer than the BBS, other than that they are the same.The fuse will blow if a tube blows. That is what its for.Voltage spikes and suc... | |
| What cables for luxman Thanks for the input! | |
| Integrating Subwoofer with ProAc Speakers.... HELP Hello Shsohis,Check out the REL site. You will find step-by-step instructions on the set-up. Put your sub in the corner of the room. If you can use high-level inputs instead of the RCAs on the Strata do so. I could not get my ER-1 to intigrate wit... | |
| VAC Phono in Avatar Super Hello Maineiac,You are not alone! I too own an Avatar Super and I have been working on clearing the problem with mine.I have changed tubes with little or no success.I was told it was my Grado wood cartridge, that it had too much gain @ 5 mv, so bo... | |
| Tube integrated for ProAc 2S Thanks for the responces! I have red a little about the original ARC integrated and it seems the reviewers feel it is good but with complex music it falls short. I don't know much about the newer one. I will check into it more. What about ARC sepe... | |
| ProAc D25 or ProAc 1SC + Sub I have not had a chance to try D25's. But have owned 2.5's and 1SC's. I sold my 1SC's to purchase 2.5's in the search for deeper bass and was sad to find that most of what I loved about the 1SC's was not there with the 2.5's. I would strongly sugg... | |
| Speaker wires for C-J PV10A/MF-2200/VSA VR-2000? A would try a shot at Kimber 8TC, double run, biwired if your speaker will allow. | |
| Good Low Level Resolution Speakers under $2K used. Yslee,I find Proacs responce line of speakers sound wonderful at low volumes and can play plenty loud without breaking up. I think with the quality of your equpment the would work well as the do demand good equipment. I own 1sc's and find the off ... | |
| CJ Premier 14 vs. 16LS..etc. I would like to second Cjlundgren's comments about cj service. I have found cj in the states to be very helpful and wonderful to deal with. Saying that, I am from Canada and my experience with Korbon Trading (Canadian Distrbutor) is far from favor... | |
| Integrated amp to drive ProAc 1sc Thank you all for your input! It looks, at this point, that "TUBES IS IT" and that has been my opinion from the start. I however was curious about ss. Keep it coming! | |
| Integrated amp to drive ProAc 1sc Gunbei,I just sold my 2.5's to return to the 1sc's. My experience of the 2.5's was not the same. I do think they are a fabulous speaker. They have great bass and are seamless from top to bottom (providing one uses good speaker wire), but I did not... |