mitchellcp
Responses from mitchellcp
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 @fsonicsmith1 Wow | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 @lewm You appear to be under the impression that everything I tried with that problem was shown on the video, that I just happened to be shooting a video as I was listening to records, as we all do, and shared this comic little problem because I'... | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 Finally!! Someone who runs balanced!! Did you read this? excerpt from the Elac PPA-2 Manual: "Typically a balanced connection will be more immune to hum, so it would be the preferred connection. However, you must be careful that the shell of th... | |
| Silver v Copper wire phono cable The first rule of buying, the choice you didn’t make was the correct decision. | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 @mijostyn take a look for yourself | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 @ejb14 1. Isn’t woofer pumping caused by infrasonic frequencies (below 20hz)? Yes it is 2. The PPA-2 has a rumble filter and I believe that I saw it turned on when the woofer pumping is occurring - doesn’t a rumble filter filter out these f... | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 Attention Deficit Disorder? You’re probably just noticing it because you weren’t paying attention before. | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 Take a look for yourself | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 as per previous post A- Pumping exists when the system set up is: Balanced output from tonearm to balanced input at phono preamp and: Stylus is over the play surface and the platter is rotating- not off to the side (it also persists with the... | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 Yes | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 @fsonicsmith I thought that if I got continuity from cartridge white pin to XLR L pin 2, blue to L pin 3, red to R pin2 and green to R pin 3, and if George Cardas welcomed to the right channel on the right side and in phase was in the middle I was... | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 Wiring for the tonearm to the preamp was as follows: Pin 1- no connection Pin 2- + positive Pin 3- - negative Shell ground- cable shield Why was it wired like that? I agree the typical connection is pin 1 for the shield. See excerpt from t... | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 @dweller , I had one of those when I was a teenager back in the late 70's, it's funny to see it again. So funny I'll have to buy one- again. | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 Let’s review, Woofer pumping is tied to rotation speed, the pumping is faster at 45 than 33 also spinning the platter by hand will excite the woofers. A- Pumping exists when the system set up is: Balanced output from tonearm to balanced input at... | |
| So Weird- No Stylus Contact Woofer Pumping with Hana ML and Elac PPA-2 I looked it up it’s 5.8kg or 12.87lbs |