larryi

Responses from larryi

Gradient Revolution
The only experience I have with this speaker is hearing the active version at two different CES shows. In both cases they were set up in small rooms, with the speaker quite close to the walls. In fact, one room was not much larger than a walk-in c... 
Are extended warranties necessary on plasmas?
Most extended warranties are a big money maker for the issuer, and therefore, a ripoff for the consumer. However, if I were to consider one, it would be for a plasma. That is because a failure of the panel, whether catastrophic, or more than a few... 
HIGH DEF DVD...WHATS THE LATEST NEWS?
Rysa4,I am shocked at your obvious, and unfounded bias against Elcaset. Remember that format?I might be waiting this one out a bit. I bet winners and losers will be settled by something like: which one is adopted into the most popular game system. 
Schroeder vs. Triplanar VII Sonic Differences
Rgordonpf,I would be annoyed by the kind of care needed to set down a periphery clamp without accidentally swinging into the cartridge cantilever.But, there is no inconvenience or danger whatsoever from the skirt on a vacuum holdown. The skirt doe... 
best preamp ever - cost is no object
I've heard a few of the contenders, some in systems I am familiar with, others in somewhat alien systems. One of the best systems I heard had the Audionote (uk) M-10 linestage and phono stage. But, that is a huge and extremely costly setup (well o... 
Schroeder vs. Triplanar VII Sonic Differences
I can appreciate the concerns expressed over the complex operation of the Kuzma arm. Long ago, I owned a Maplenoll table with an air bearing arm and air suspended platter. It came with a cheap aquarium piston pump and nothing else (no dehydrator, ... 
Spikes versus Rubber on wood floor?
Whether to couple, decouple and dampen, etc., is determined by experiment. Theory does not help because whether any result is positive or negative depends on a wide range of factors. With a suspended wood floor, coupling will mean that the floor w... 
Upcoming plasma 1080p tv's vs Sony SXRD LoCS?
I own an SXRD set (the Qualia 70" RPTV), so obviously, I like that technology. But, that is not to say that plasmas are not acceptable. They can look very good and may be better in some applications. Where light control is not very good, the highe... 
Schroeder vs. Triplanar VII Sonic Differences
I read somewhere that the agreement between Herb Papier that granted Tri Mai the rights to manufacture the Triplanar arm specified that the design could not be changed for a certain number of years. Perhaps this is why the design seems frozen for ... 
Cary 300SEI vs Art Audio PX-25
I don't know about use with phones, but, with speakers, the two are quite different in sound. The Cary is extremely warm and lush sounding. The PX-25 is much more neutral and nimble sounding. I really like the PX-25 on speakers much more, but agai... 
To bi or not to bi-wire Spendor S8e
I know two Spendor dealers who insist that, for any given dollar expenditure, it is better to buy one good set of cables than to bi-wire. However, they both insist that putting in better jumpers is a must-do thing. These jumpers can be, themselves... 
do planar or electrostatic speakers inherently
From my experience, the answer is yes, when you are talking about typical dynamic speakers, but, horn systems and other high efficiency systems also sound very good at lower volumes.Another low volume phenomenon that is a big advantage of dipoles ... 
can changing 6sn7 tubes affect the output voltage
I am not familiar with the Supratek gear. From your description, it does not sound like it is possible to tweak the bias. Amps that allow for such bias change would have a knob and either a meter or a place to plug in a meter to make the adjustmen... 
Q- is Columbia CS 6 eye better press than 200 gr
The 6-eye Columbias are, generally speaking, the best you are going to get. I suspect that it is a matter of the master tape degrading over time (which is why Sony and Philips developed DSD to archive recordings in the first place).The "Kind of Bl... 
can changing 6sn7 tubes affect the output voltage
Your EML 45 failure was probably a coincidence. By the way, a friend of mine had two pairs of EML mesh 45s fail within ten hours (total for both pairs), so you got a lot more mileage. The replacement pair of solid plate 45s have been going strong ...