juliejoema
Responses from juliejoema
| High Fidelity Cables CT-1designed by Rick Schultz The initial 'dull' sounding impressions may be due to the lowering of noise. Noise, as opposed to the intended signal, sounds 'louder' than music of the same measured dB level.So if you reduce noise levels, you are reducing the APPARENT loudness o... | |
| High Fidelity Cables CT-1designed by Rick Schultz Hello Rx8man,I have used VD UltraClear, 'regular' CT-1, and the enhanced. There was nothing specific that was better going to the CT-1E, but EVERYTHING was just noticeably better. I would not have believed it, since the jump from regular copper/si... | |
| virtual dynamics new ultra clear interconnects There is a preferred direction to the cables, and it is imperative that you get the same polarity of the magnets at the source and pre/amp end.First, get a compass and find our which end of the cable attracts the 'north' end of the compass needle.... | |
| Anti-skate Theoretically, there should not be a change in friction between inner and outer grooves based on 'linear' speed at the stylus. With dry friction, only the interface between the two surfaces and the amount of vertical weight affect friction.Since V... | |
| RS-3 owners: Seeking anti-skate help First, Thank you Quiddity for explaining the skating force. I understand it now.With the RS-labs arm, however, the suggested alignment results in the elimination of skating force at one point (suggested by the manual to be slightly 'inside' (towar... | |
| RS-3 owners: Seeking anti-skate help There is no need for anti-skating force because the stylus is perpendicular to the armtube. The reason you need anti-skating for offset headshells is because the elliptical/line stylus is rotated by between 19 degrees and 23 degrees from the line ... | |
| KAS Audio PC anyone? I've got a Kaiser XT power cable that works great on my Primare 30.5 power amp (used for bi-amping with 4 channels used). It sounded way better than a VD Power One and a non-helix Shunyata Taipan. The imaging and depth was greatly increased compar... | |
| RCA Splitter to Bi-amp? You might want to have someone make up a split cable using six RCA connectors and four runs of IC cable. This will eliminate a connection, and probably give you better sound..On a further note, I have been using a 30.5 for bi-amping for years. The... |