jpjones3318
Responses from jpjones3318
| Just bought Technics SL1000 MK3 need to buy/borrow platter removal tools What do you use to stick it? I just set mine on without any adhesive. | |
| Just bought Technics SL1000 MK3 need to buy/borrow platter removal tools M6 | |
| Just bought Technics SL1000 MK3 need to buy/borrow platter removal tools The lift handles are M6. Universal pin spanners work well for the nut, though the holes are 3.5mm while most cheap universal spanners use 4mm pins. You can use those but will need to file the pins down. There are a few out there that are 3mm: http... | |
| Victor TT 101 vs TT 81 Hi, best grooveIt was a cut caused by a scrape that was under the solder mask, so a manufacturing issue. Nearly the entire trace was cut, except one small corner at the edge of the solder filet, which cracked right at the very corner causing the ... | |
| 'Diamond' cantilevers: a man's best friend? From this follows that ''one piece'' diamond /stylus combo like by Sony 88 D is superior to glued in styli.:)http://fidelisanalog.com/2018/10/20/sony-xl-88d/ | |
| Upcoming Technics SP-10R (100th Anniversary Model) Thanks, Lew. Hope you’re doing well. | |
| Upcoming Technics SP-10R (100th Anniversary Model) Haven’t seen an update yet from JP. Sorry. I scribbled out a couple thoughts for you. | |
| Best vintage DD turntables from the 70's and 80's? According to the vintageknob the signal-to-noise ratio went from 78dB on the P3 to 95dB on the P3A, so I suppose it is correct to assume it is (much) better.There's also a footnote explaining that. | |
| Cartridge repair; re-tipping; canitlever replacement: The Needle Clinic A++ In this thread: https://forum.audiogon.com/discussions/fabulous-technics-epc-100-series-re-tip?highlight=technics%2B... | |
| Cartridge repair; re-tipping; canitlever replacement: The Needle Clinic A++ While a horribly expensive lesson for me, I'm glad that it seems he's finally standing behind his work, and hopefully actually doing what customers ask. | |
| Upcoming Technics SP-10R (100th Anniversary Model) Someday I'll have time to write-up my thoughts. | |
| Technics Sp10 Mk2 vs SL-1200G - I finally did an A/B All, The fastener holes on the MKII, MK2A, and MK3 are in the same location. A MK3 will fit in a MKII/2A plinth (SH-10B3 or B7), though a MKII/2A will not fit in a MK3 plinth (SH-10B5) as that plinth has a smaller cutout for the round back can of... | |
| Upcoming Technics SP-10R (100th Anniversary Model) Doubtful. The version sold here is world voltage and comes with four different power cords. I think the one sold in Japan is at least with different accessories as mine didn’t come with the usuall two-prong with ground wire break out that my Jap... | |
| Upcoming Technics SP-10R (100th Anniversary Model) Maybe. A good deal of what's on Yahoo have the tell-tale signs of damp storage. | |
| Upcoming Technics SP-10R (100th Anniversary Model) I'll post something on my blog when I finish my testing, but it is good. Really good. |