grey9hound
Responses from grey9hound
| Interconnect with great dynamics and bass slam , AudiolabyrinthI am here . I have been trying to fix a problem with one of my Sony CDP-M555ES cd players . it has started not being able to find the disc location and spins around back and forth searching for the right disc # . It plays fine until ... | |
| Interconnect with great dynamics and bass slam , WaxwavesI am waiting for you review. I look forrward to it . Thanks to you and Audiolabyrinth for all of your insight | |
| Interconnect with great dynamics and bass slam , AudiolabyrinthI am here . i was just busy this past weekend.WaxwavesDid you get the cable yet ?When you do , would you try it between the cd player and pre-amp . I think most systems would allow you to hear more differences in that position.I know... | |
| Interconnect with great dynamics and bass slam , Well, I put the Q10 Speaker cables back in on the top . I ran Audyssey again , even though i play music in direct mode,without sub. The Audyssey corrections are not supposed to be applied in this situation, but i believe it actually does. I always... | |
| Interconnect with great dynamics and bass slam , @AudiolabyrinthMy amp is 125 into 8 ohms and 225 into 4 ohms. THD is .04%29db Gain | |
| Interconnect with great dynamics and bass slam , ICs are MOST noticable between source and pre-amp.Any one agree? | |
| Interconnect with great dynamics and bass slam , @Waxwaves . You should put them between the Souce and the pre-amp first . That should be where you would hear thee differemnces the most | |
| Interconnect with great dynamics and bass slam , Thanks again to all for the recommendations and the help.@Audiolabyrinth. -- I am not going to use jumpers on my speakers. I am going to continue t bi-amp them, unless i get a more powerful amp, which i have not planned on yet . I have considered ... | |
| Interconnect with great dynamics and bass slam , AudiolabyrinthClick on me "Grey9hound" its in My System | |
| Interconnect with great dynamics and bass slam , well, i did not give them a full 200 hours , but about 100 hours. Audiolabyrinth, i am not using any jumpers ??? i don't know if you do not understand what bi-amping is or not ??you keep talking about jumpers vs bi-amping ???Any sopeaker that has ... | |
| Interconnect with great dynamics and bass slam , Tls49I have used identical cables with the Q10 and with some previous 12gauge cheap stuff.Thw Q10 is setup for bi-amping(4 terminals on each end ).I had been doubling up the four connections into two when they were on top and the Synergistics on t... | |
| Interconnect with great dynamics and bass slam , Audiolabyrinth , #1. My Amp is not powerful enough to drive these speakers to the level i want without bi-amping.I tried running this way with jumpers and two amp channels instead of four . #2 The sound is more open sounding and dynamic when i am ... | |
| Interconnect with great dynamics and bass slam , one amp with four channles for two speakers | |
| Interconnect with great dynamics and bass slam , My last question here was asking which interconnect should i use for the pre-amp to amp on the bass cahhels . I am bi-amping . This is for the pre-amp to amp ( the bass channels to the speaker) .they are crossed over @ 150 hz . So the signal from ... | |
| Interconnect with great dynamics and bass slam , Well i am bi-amping. When i say that i am using Golden Cross ICs from pre-amp to amp on both channels for each speaker . The way i said it makes it sound like i am talking about speaker cables because i said that i am using GC ics on the top and t... |