foeraus
Responses from foeraus
14 ohm 7” midrange driver Also....I have seen that the drivers are "custom" also.....vs, the Scanspeak standard model. But that could just be the printing of ProAc on the dust cap. LOL | |
14 ohm 7” midrange driver Good info. Thanks! | |
14 ohm 7” midrange driver I was just looking at the same for my ProAc Studio 200s. Don't see my 6 1/2" mid-woofers, as they are also marked as 14 ohm. Did you find if the 8 ohm were correct for your Response 3.8s? The other option I was going to look in to was Millersou... | |
Annoying trend? New vinyl equalization and compression dogberry 361 posts 10-06-2023 at 03:24pm I don't know that it is a new trend: there have always been dreadful sounding records of otherwise good music. You have to know which ones you have and refrain from using them when comparing two pi... | |
My ProAc Studio 200s are…. Unfair assessment? I don’t believe I made any blanket generalizations……as the topic mentioned, it was all about the results with my ProAcs….and I tried to describe specific differences in sound and the results. | |
My ProAc Studio 200s are…. ”My sentiments exactly with a lot of decent tube amps mated to transparent speakers.”👍🏼 | |
My ProAc Studio 200s are…. Actually too…..making the amplifier swap made me re-assess that the Rogue was sounding a bit chesty on voices…..basically a little thick in the upper bass and lower midrange….and a little rolled off on top. A swap from the installed Tung Sol reiss... | |
Has anything changed with Grado cartridge re-tipping? No more Needle Doctor.... @orpheus10Well, with the above information, I can just order online when necessary.Yeah, thinking I will spend the extra and upgrade to the 1.0 mV Master3 this time from my Sonata2. | |
Has anything changed with Grado cartridge re-tipping? No more Needle Doctor.... @yogiboy I had an MCZ years ago....replaced with TLZ before the wood cartridges. Wish I had kept the TLZ for spare or comparison. I also saw while looking for retip info that it is easier to get a MCZ/TLZ/XTZ stylus now!Turns out some 8 years ago ... | |
Has anything changed with Grado cartridge re-tipping? No more Needle Doctor.... When My inner track on albums starts to get inner groove distortion (distorted on peaks or sounding a bit hazy/compressed), I know I am about due.I had some 30+ years ago waited too long in recognizing and replacing stylus/cartridges and damaged s... | |
Has anything changed with Grado cartridge re-tipping? No more Needle Doctor.... Yogiboy.....Thanks! That was exactly what I was looking for! Would have loved to just find this on Grado or 4ourears website.Like I mentioned, I love being able to make an instant swap of the cartridges...Did you just replace yours? What did you g... | |
Has anything changed with Grado cartridge re-tipping? No more Needle Doctor.... The important point here........Needle Doctor would send you the new cartridge.....then give you some 7-14 days to return your old one!No one else I found does this. | |
Has anything changed with Grado cartridge re-tipping? No more Needle Doctor.... My fifth paragraph mentions that I will probably call Grado tomorrow.But today being Sunday.....was hoping someone knew of a Grado dealer that had a Grado replacement procedure like Needle Doctor had.The third-party retipping are other people’s su... | |
Has anything changed with Grado cartridge re-tipping? No more Needle Doctor.... I have thought also about the Soundsmith re-tip......though I preferred the Needle Doctor type of immediate swap if it is somehow available.Under magnification? Do I have a tool to do this??? | |
Versatile, non-fatiguing speakers for a small room under $1500 used or new: advice needed! https://youtu.be/_s0zrFeglIQFound this video......Not extremely common N.E.A.R. 15Ms fit your description well....near full range in a large bookshelf....not bright at all.....great for jazz, rock etc. Again, great bass! Well defined and reaches t... |