deanrk
Responses from deanrk
| Who remembers California Audio Labs? I believe the Adcom GCD-750 (still have as a backup) was a CAL design. I have a schematic with their name on it. | |
| Aerial Speakers I’ve had my 7Ts for several years and still enjoy them. They are now set up in a smaller room (15.13.12 that’s a whole other story) and I’m still tweaking their position. Latest position now lets me “hear” bass notes for a lot of music. Yes, I a... | |
| Oxidation on surface of cable under clear jacket ANCs = and I also have duhhhhh | |
| Oxidation on surface of cable under clear jacket Inagroove Good advice. The 12TCs I have areindividually insulated single strands. I’ll give them a close exam before I connect them. And they’re about 3 yrs old I’m out of town for about another month. And then another listen. I was also lookin... | |
| Oxidation on surface of cable under clear jacket Almosthome your guess is better than mine! Thespeakerdude outside sheathing is on the thicker side which does afford protection from objects cutting through, but not air infiltration | |
| Oxidation on surface of cable under clear jacket Winoguy17 yup Mine are worse than that, but that’s it! And I think as your picture shows, the clear sheathing may be pulled over the copper conductor which allow air infiltration and oxidation to take place. But when I set up my system in our ne... | |
| Oxidation on surface of cable under clear jacket 61falcon. I lived in northern VA. Summer humidity could get high, but home was air conditioned, so I doubt high humidity had anything to do with it. Felixa I will put them back into my system and give a listen. AND I have a pair of Kimber Kabl... | |
| Oxidation on surface of cable under clear jacket Steve. Thanks for the recommendation. | |
| Oxidation on surface of cable under clear jacket SOIX. Sounds like a good suggestion. I’ll give them a try Thanks | |
| Oxidation on surface of cable under clear jacket This must be a common problem for uninsulated copper mesh cables. Looking at other manufacturers sites and most guarantee their cables for life. But they have “coated” wires. | |
| Oxidation on surface of cable under clear jacket petg60 Thanks for the quick reply. Yes Analysis Plus Oval 9. Kind of disappointed that they weren’t sealed from the elements. And if I can’t repair them they get tossed. In the meantime, I have a pair of Kimber Kables I can use | |
| Right Channel dropped out Bryston BP-26P (upgraded from BP-25P) IMHIFIFAN. Meaculpa. After reading your last post, I unboxed the amp and………yup switch was in MONO! And I’m sure I checked that. Reinstalled the amp in my system, quadruple checked ALL the connections and switches, powered up the system and It wo... | |
| Right Channel dropped out Bryston BP-26P (upgraded from BP-25P) Imhififan. That makes sense to me. I boxed unit yesterday to send back to Bryston. I’m awaiting their response. Thanks much | |
| Right Channel dropped out Bryston BP-26P (upgraded from BP-25P) SOIX. Yes PA works fine with Adcom GFA-1OLDHVYMEC. First. I’m listening to system with Adcom in system. All sounds fine. Right channel working fine. Bryston uses a magnetic master circuit breaker switch on rear of amp. It didn’t trip but I did re... | |
| Right Channel dropped out Bryston BP-26P (upgraded from BP-25P) SOIX Doesn’t/didn’t make any sense to me either. Tried unplugging everything and starting up again. NoGo. Nonetheless, set up GFA-1 to preamp and a pair of RadioShack Optimus dipoles I had hanging around (just in case there was a bigger problem ... |