2. amps-preamps
  3. 1341412969

6550 Tube Blew - A Few Questions

Hi. While listening to my system the other night, I noticed one of the power tubes for the right channel glowed extra bright, and static came through the speaker. I immediately shut down the amp, and haven't turned it back on.

Is it possible to check for damage to the other channel or other parts of the amp without installing a new tube to replace the blown one? I don't want to buy a matched pair and then discover that the amp has other damage.

Is it safe to test each channel with the other channel's tubes removed? Thanks!

Terry
128x128rwinner
rwinner's avatar
rwinner OP
37 posts
 
Hey, that was a great post. I think I found the resistors you said on Ebay (who has 50 watt resistors lying around? :) ), and I'll start on these tests as soon as the tubes arrive. Thanks a lot!

Terry
marakanetz's avatar
marakanetz
5,473 posts
 
Forgot to mention that I prefer to bias amps on dummy load instead of speaker. When I owned VTL, I implemented switch to dummy load and used it even if I wanted to simply stand by the amp with no listening(only in case if I plan to listen to it multiple times per day).
rwinner's avatar
rwinner OP
37 posts
 
Ok, thanks for the info. I didn't know about the bias resistor blowing. I'll certainly call Jolida today and ask about it, and where I can obtain 0service if necessary.

Iirc, the same thing happened once before, and I didn't need to replace a resistor. But, I was thinking, if its just a resistor, shouldn't be too difficult to do myself if I can be told which resistor. Another reason to call Jolida and do some Googling.

Terry
rwinner's avatar
rwinner OP
37 posts
 
Well, I got the replacement tubes today, replaced the right channel with them, and am not getting power at all.

I checked the fuse, and it was still good. I checked inside, and could see no obvious damage or the smell of something burnt. What are some of the obvious things I can check before I bring it in for out-of-warranty repair?
marakanetz's avatar
marakanetz
5,473 posts
 
Did you ID the bias resistor as mentioned above?
I believe that you have 2 tubes per channel and bias resistor is shared between two tubes. It's realy not hard to ID low-resistance resistor and test it for open circuit.
More to discover