Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
That's funny George... Every so offen I switch between my Audilble Illusions 3B and my Bent... One day I'm going to breakdown and buy a Lightspeed. But I'll go with the stereo unit cause having a dual mono can make you nuts, especially when you are one click off...

Tony
I think I could only deal with dual mono controls with steps and 1db increments in the 12:00 region. I like to balance, but dual controls would drive me nutz.
Just picked up a lightspeed. Here's what I have,how can I get it to work best with the lightspeed.
Krell KSA 50S amp
Music hall CD 25 transport - Black Cat Veloce ic - Rega DAC
AU 24 ic or Straley ic or Morrow ic to preamp same to amp
Clear Day or Straley speaker cable to Tekton Lore

My ears are the ultimate test but am I off to a good start?
The input sensitivity and input impedance of your amp are fine. The input impedance is 47k ohm which is at the lower end of what the LSA likes to see but will be just fine as I've used mine with lower. The output voltage of your Rega DAC is fine too. What we don't know is the output impedance of the DAc but given that it is a solid state output it should be under 200 ohms so you will be fine IMO. Give it a listen.