2. analog
  3. 1412821921

Roxio 'Easy' LP to MP3

Just bought this device to upload some audio tracks that i have remixed/mastered using an Aiwa AD-R707 analogue cassette deck.

Acc to the manual-- unless the analogue source has a pre-amp, the Roxio will have to be fed from my receiver & not directly from the RCA outs on the back of the deck or the headphone out jack on the front of the deck. The headphone out jack does not have a vol level adj.

Does anyone know if there is a pre-amp inside my AIWA or a recommendation of what might be the best way to proceed?

Ciao
roscoe50
roscoe50 OP
44 posts
 
The manual says turntable OR tape player....
casey33
260 posts
 
The Pre-amp just raises Phono to line level.The cassette is already line level.Like Mofi said,direct.You won't need Volume Adj.Roxio will set that.
roscoe50 OP
44 posts
 
What would be the best--- using the headphone connection on the front of the deck or the RCA's on the back?

Thanks for responses.
mofimadness's avatar
mofimadness
4,943 posts
 
RCAs on the back. The headphone output would run through a headphone amplifier. No need for more electronics in the signal path.
roscoe50 OP
44 posts
 
If there is no need for more elec than necessary, what would be the effect of feeding the cassette into my Amp b4 feeding the Roxioanyway.

This is after all what the manual says if there is no 'preamp' in the analogue source.

Thanks again for responses.
More to discover