@deep_333 wrote:
What horn subwoofers do you use? DIY? or something else? I might be interested in getting one.
They’re the tapped horn principle, DIY and called MicroWrecker (a sibling to the LilWrecker tapped horn, which has a 5Hz lower tune for a 50% addition in volume (30cf.) and ~3-4dB hit in sensitivity). I got the plans over at AVS Forum from a developer there, and had them built by a cabinet maker. The developer also simulated drivers for the specific design in the Akabak (or Hornresp) software, and so had a range of suitable woofer choices to go with. These have to have the proper electromechanical parameters within a fairly narrow window in a given tapped horn design for them to work the best here, which is to say to properly resonate the horn; too weak a motor and the horn isn’t "excited" enough, and too powerful a motor will compress the air too severely at the throat, also leading to insufficient horn resonation. The B&C 15TBX100 (8 ohm) unit I’m using sits right in the middle of the desired performance window here, and so is close to the ideal driver for the purpose. Close, because it lacks the very last bit of excursion range to be fully exploited at its rated power (1000W nominal power handling, 2 hour pink noise test, free air) before hitting Xmax in this design with a ~23Hz tune, but it’ll take 600W up until that point, so perhaps a theoretical 2dB SPL subtraction overall. Fine with me, as a single MW will still do over 120dB’s down to 25Hz with the B&C unit, and I have two of them - corner mounted. The same driver is used in Danley’s TH-115 subs, but being this tapped horn design has a higher tune the driver can be used at full power here.
Size of speakers doesn’t seem to scare you off, but be aware it’s still a 20cf. volume per cab. When you see them "in the flesh" it can a bit unsettling getting a feel for their true size, I know it was for me at first. In the same ballpark there’s also great designs by Josh Ricci over at Databass.com, notably the Skrams, Skhorns and Othorns. The latter is also a tapped horn, though built around the 21" B&C 21SW152 woofer - a beast - and with a ~28Hz tune. Initially I intended to have a pair of the Othorns built, but the woofers were out of stock for months, and so I opted for the MW’s. The Skrams are a great design as well, and more driver "friendly" than the Othorn. Meaning, a range of 21" pro woofers can be used here, whereas the Othorns are only fully pleased with named woofer or its IPAL equivalent.
The inspiration for the MW’s were Danley’s TH-50 tapped horn, and they’re very much alike in vital areas. Josh Ricci opted to develop the Gjallarhorn tapped horns instead (also inspired by the TH-50), which is built around TC Sounds LMS-Ultra 5400 driver (18"), but that driver is no longer built. A beast of a sub, and about the most one can squeeze out of an 18" woofer, I’m told. They’re tuned a bit lower than the MW’s, but I never truly considered them as they are too monstrously sized (plus more than 300 pounds w/driver) and a bit hampered in their upper range due to the slightly lower tune.
In any case any of the above designs are extremely capable in putting out high quality bass at prodigious SPL’s and low distortion levels - certainly compared to most any low eff. "hifi" subs out there.