Vibration Question


Warning to the sensitive: involves tonearm pods.

I know this topic is beyond the pale to some, but my tables cannot take a second tonearm (once upon a time, though, they did), and I enjoy variety in cartridges. I have bought four pods so far from Lee Drage at Acoustand, two plain and two with built in micrometer VTA adjustment. But I discover the airspace around the tables is too congested with six arms, as well as introducing some grounding issues. So, as I told pindac the other day, I started to experiment with using two pods per tonearm. Not just a simple 'if one is good then two must be better' but for practical reasons. Firstly, a pod resting on three spikes weighs about 10lb, but it doesn't take much pressure on the distal end of the arm panel to cause it to tip. One can spoil a carefully set up alignment that way, and if it continues tipping a disaster could happen. So, I thought, why not place a pod under the distal end of the tonearm panel, and prevent that happening?

But then a second thought came along: if the second pod were firmly coupled to the panel, I would double mass and damp vibrations even more. That's a bit theoretical to me, as my oak chest weighs ~350lb and I can stamp on the floor next to it and not disturb a playing stylus. But rigidity is rigidity. So I asked Lee if he could make me a double ended panel with an SME mount centred in the middle. Roughly, like this:

He agreed, and pointed out I would have to forego the VTA adjustment, unless one were to place a screw at each end! I can use the SME mount itself to adjust VTA. though, so that's OK.

Here, finally is the question: he thinks I am simply introducing twice as many vibrations (external, I think he means) into the tonearm by having it rest in two sites on the oak chest, and that I would be better off having one end of the tonearm panel free-floating. My view is that rigidity is paramount, and if a built-in tonearm on a table is firmly coupled to the table then I am moving a bit closer to that ideal by having a firmly coupled chest-table-pod system. What say you?

dogberry

This is not a Plug for a product, but as their are plenty of measurements shown as part of the R&D for this design, and I am familiar with such type of recording being shown, through spending time with individuals who show to me their own recorded data for their own designs and works undertaken. I though it might be off interest for some to see the Vibration being present and the impact it can have.

The OP has certainly met suggestions for improvements to be put in place for  Vibration management being utilised for their TT's mounting.

 

The panels arrived from Acoustand today and it all seems to work. Very heavy and solid, so should be stable.

A few pages back I outlined my plans for some experimental double tonearm pods. The panels arrived from Acoustand today and it all seems to work. Very heavy and solid, so should be stable.
 
[IMG]
 
[IMG]
 
[IMG]
 
[IMG] 

The Thread has moved on from the initial intoduction of :

' Warning to the sensitive: involves tonearm pods.'

An Update

Warning to the sensitive: involves tonearm 'Bipods.' 😎