Preamp


Have an audio research sp6 thinking about changing to sp20

worried about loosing warmth

anycomments

castner

If you only could have 1 which 1?

any other people to comment?

while I have attention I wonder if anyone can suggest a better cartririge

i have a dyavector 20x2 low output moving coil now 

Alternate Cartridge: Preferred/Better are separate considerations.

Sound Characteristics (do your research) are preferred, not better.

Imaging, is better, not preferred (good, better, best) and is vitally important. Imaging is improved by wider separation and tighter channel balance. The difference is easily recognizable.

Regardless of Phono EQ, Preamp, Amp: start with better imaging out of the cartridge. Change your Phono Stage, it will be the same: (preferred, not better) In any case, it receives better wider/tighter signal

your 20x2 produces 25db of stereo separation (mediocre), and 1db channel balance (good but 0.5db better)

Cantilever: 20x2 is solid aluminum rod. I never heard that. Stiffer material is better, in my experience: especially tighter bass. Boron, and Crystals are Stiffer than aluminum. I get Boron, not just a bit less money than crystals, but less likely to shatter a boron cantilever than crystals. IF you can afford them, and be very careful with it, then go for a crystal cantilever. I have a Sumiko Talisman S with Sapphire Cantilever, more/tighter bass?

We can convince ourselves of anything, but it seems so. I use two wonderful LP’s, ’Cecil McBee – Alternate Spaces’, (India Navigation – IN-1043) and ’The Bass’ (3lp set) (Impulse ASY-9284-3), an amazing collection of music/musicians/engineering.

All advanced stylus that are close to the shape of the cutter sound great to me. I have heard MicroLinear; MicroRidge; MicroLine; Line Contact; SAS; Shibata; Van den Hull; Geyer II. You can never do a direct comparison, each was on a different cartridge, so I would not let which advanced shape be the determinant.

All advanced stylus shapes MUST be properly aligned.

MC Moving Coil: Low or High Output. Low Output allows smaller/lighter coil, thus theoretically Low allows the advantages of MC, more refined signal. I have only heard Low Output thru my Step Up Transformer.

MI, Moving Iron: I have never heard one, highly respected by many.

You are better off with a Hana ML setup correctly than a Hana Umami Red setup incorrectly.

TTSETUP.com  

due to the three Stylus/ Cantilever manufacture we are at the mercy of them. If you setup the cartridge just using the cantilever, 9 out of 10 times you will be wrong. It probably won’t sound horrible but it will not be perfect. On some styli they will sound good but you will be doing irresistible harm. If you want to spend $1200 to $4,000 on setup equipment then so be it. For $400 plus travel sometimes your cart will be setup with the least amount of problem and distortion. Once Azimuth and more importantly Zenith are setup correctly you can play with the VTF or cartridge weight to get the sound you desire or that sounds right to you in your system 

Brian, The owner of ttsetup.com travels to most of the shows east of the Mississippi. If not he does have clients that pay him to fly out and setup their gear. 
I hope this helps. It sounds like $400 is a lot. In the end it will be the cheapest part of your vinyl rig. Equipment and vinyl are expensive.