One DAC to Rule it All


Sorry for the "click-bait" headline. The digital side of my system is an Auralic G1 sending to an OKTO DAC8 Stereo. I like the sound a lot, but I also use a DBX Venu360 digital crossover system to split the signal to my mains and subs. The DBX gets an analog signal from my preamp (Benchmark HP4), but to do its function the DBX unit converts to digital, then back to analog at 96Khz. My question is, since the DBX unit has the capability to receive a digital signal (AES/EBU), would it be better to use just one DAC (DBX) to do it all, or stick with the double converting and keep the OKTO in the system?

koestner

My subs are 15" drivers in a 3 ft^3 sealed box. They are powered by a Crown 2500 amp, and the drivers are 4 Ohm. My listening room is large because my home is an open floor plan and the system is in the living room. 

I'm going to the Tampa hi-fi show tomorrow and I will ask around what others are doing too. For now I will stick with the DBX unit to learn all its functions before ditching it for something else. That way I will have more knowledge before embarking down another path. I'm interested in the DEQX units, but they are delaying their release of some new pieces. I don't know why.

@koestner 

I am one of the people testing the Beta programing of the new DEQX units. My Pre 8 is due to be shipped out next week, FINALLY. The first thing that happened was COVID and they lost the supplier of the main processor they were using. They wound up redesigning the units around another, even better processor. It also required revising the programming. All this took two years. Then, a problem developed that required redesigning one of the boards and finally two out of the first 100 units built developed the same intermittent problem. They wanted to make the diagnosis before letting the other 98 units go. They are all PRE 8s by the way. Most people will require only PRE 4s. It is the identical unit without the 4 way crossover. It won't be available for at least another 6 months. So, take your time and play with the dBx. I've been doing the digital thing for almost 30 years starting with a Tact Audio 2.2X and I am still learning. 

Your subs are passives! Did you build them? I have the same situation as you, an open floor plan and passive subs in a large room. Two 15's will do a lot of damage and is enough for a point source system. 

Well, my subs were originally Velodyne DD15', but over time both plate amps broke down and even the one I got repaired broke again. That was it for me, so I opened them up and ran the driver wire to some banana jacks that I installed on the plate amps. So they still look like DD15' (nice glossy black), but they are now passive.

Maybe I'm missing something, but if you go digital into your Driverack, where are you doing your Volume control?  You'd have to do it digitally, before the Driverack. What are your choices of an all digital preamp?

I have done this with a Lynx Hilo (just messing around).... as it does digital routing and attenuation, and has multiple digital Ins & Outs.  It's a very cool studio tool, but sadly does not have remote control.  I did not notice any compromise in performing digital volume control with a 24bit signal path.

 

@mijostyn This is the first I’ve heard of DEQX. In your opinion, will the DEQX Pre4 outperform the MiniDSP Flex (I have considered that model with balanced analog connections)?

-Ed