McIntosh with Klipsch Palladium P17B


Hello looking for recommendations for a McIntosh power amp, Tube or Solid State?
Looking to power the Klipsch P17B. Would like 200 w or less.

Downsizing to an open air  floor plan approximate 1000 sq ft. I would like to add a streamer at a later date and would like to have a tuner built in or… Open to suggestions.

I presently own a McIntosh MC 2255, C33, and a MR 78, All have the wood cabinets. I have owned and have had the units maintained and serviced. I have the original boxes also for over 35 yrs. 
They have sat in an inclosed wooden cabinet the same amount of time, the cabinet was specifically made for this. Enjoy and thanks for any recommendations for the Klipsch.

longball44

From Stereophile:

The P-17B's claimed sensitivity is 94dB

The P-17B's tweeter may have been a bit too airy. It seemed to blend incredibly well with the midrange driver, sounding very neutral through the low and mid-treble, then rose slightly in response through the 11–15kHz range. A hot response in this band doesn't usually result in a hard-sounding treble; instead, it adds the feeling and sound of "air" around instruments. Many older listeners may welcome the way the P-17B did treble—it could add back a little of the high-frequency range that time has taken from their ears. However, since many pop engineers and producers already overcook these frequencies—the ubiquitous +10dB bump at 10kHz given most pop vocals comes to mind—sometimes the Klipsch gave me too much of a good thing.

When the Klipsches and Manley played together, I got too much of a good thing: While the sound was never shrill or hard, it had a little too much of that airy treble quality. My low-powered and mellow-sounding Pass Labs Aleph 3, on the other hand, never sounded as clear or as powerful as through the efficient P-17Bs.

Don't get tubes, get solid state MC-152. 

I'm a McIntosh dealer and have heard a lot of their gear over the ten years or so I have been. 

I don't think there's a right answer in terms of tubes vs. SS. And in my experience, as you move through the McIntosh line, their gear can sound pretty different. 

The MC152 is a good amp. I think the MC312 is better and big picture, worth the extra money. I personally own the MC462. It's almost twice the price of the MC152. However, you didn't mention a specific budget that you're looking to stay within and for my money, the 462 is a sweet spot in the line. It's the first and only stereo Quad-Balanced amp. It's dead-quiet and drives just about anything with effortlessness and a sense of ease. 

I also have a fair amount of experience with the MC275 which is a gem of an amplifier in its own right. Voicing isn't so different from the SS transformer-coupled Mac amps, but it does offer an added dose of "classic-tube" sound. You may also be inclined to further tailor the sound to your liking by rolling tubes and the 275 opens that door. I find the Mac-branded JJ tubes to be a little devoid of verve or personality. Not bad, just not exceptional. I've found other combinations that fit my tastes better. I've driven speakers from Kef (R5) through Magico (S1) with a single 275 and have never once heard a trace added energy up top. 

Where things change a bit is with the direct-coupled amps such as the MC830s and the MA252 and 352 integrated amps which I find to sound a little "dryer" or less colorful. I personally find them to pair better with a speaker that's voicing leans toward the warmer side. 

I can't speak to the vintage gear you have and if you want to keep it, that certainly factors in. At the end of the day, if you have a McIntosh dealer in driving distance, I think I'd consider packing the speakers up and taking them in for a listen on either a 312 or 462 (most dealers should have one or the other on hand) and also a 275. You may also want to experiment with different transformer taps. While it may seem counterintuitive, matching the speaker's nominal impedance to the amp's corresponding tap hasn't always worked best in my experience. 

I'd advise you to see if you can borrow amps, but transformer-coupled SS mac amps are back-breaking-heavy, and those glass faceplates are fragile and expensive... Your speakers are easier to move. 

Also, I think it's worth noting that in the real world, a mild rise in frequency response from 11-15K may not be an entirely terrible thing. I'm in my mid 40s and I don't hear as well as I once did, and I find myself wanting for a little air on top with more systems these days. 

 

@djmika 

Thanks for posting, do you have any opinion on the Mac MB-50 streamer? I use Play-Fi around the house and was thinking about that unit. Thanks

Kota - 

Honestly, I don't have much experience with Play-Fi. As an integrator by trade, we tend to take a little different approach for whole-house music systems. As for Mac, I've never NOT liked anything digital they've done. Their DACs have always been quiet and smooth sounding. I don't necessarily agree with their stance on MQA but that's another story. I suspect this unit is no different. That said, it is out of production and limited to dealer's stock on hand if you want a new unit. I'm not yet aware of a direct replacement. 

I just did a cursory search for Play-Fi "transport" devices you could use with a McIntosh DAC. Finding one new that'll work in a Hi-Fi system seems a little difficult these days so if Play-Fi is important to you, I think I'd call around and try to find an MB20 soon!

 

Micah