2. speakers
  3. 137322-89000

Considering the New Tekton Design Encores? AND Owners Group - Experiences/Questions

I am the very happy owner of the first pair of New Tekton Design Encores and I thought I would create this thread to answer any questions anyone might have regarding the Encore speakers, room considerations, and associated equipment. If you’ve order your pair already, please chime in. I really want to hear what other people’s experience are with these unbelievable speakers.

I drive my Encores with both an Art Audio Diavolo SET 300b Tube Amplifier with 8wpc and I switch in my 700w Nord One-Up SE Monoblocks for non-critical listening and some big pieces of music that benefit from the extra power.



  • Made under U.S. Patent 9247339 with multiple new patents pending
  • Proprietary loudspeaker design
  • Ultra-linear frequency response with ±.5dB deviation from 70Hz-20kHz
  • One single crossover element placed within the tweeter path
  • Ultra-linear, entirely time-invariant minimum-phase mid-range section
  • Proprietary patent pending 15 dome radiating hybrid MTM high frequency array
  • Two 6.5" mid-bass patented ’overtone & harmonic’ transducers
  • Dual 11" low-frequency transducers
  • ​96dB 2.83V@1m sensitivity
  • 4 Ohm design for optimum performance
  • 20Hz-30kHz frequency response​
  • Dimensions Width 13.25" x Depth 15.25" x Height 62"
  • 800 Watt power handling
  • Weight 175 lbs​
128x128jcarcopo
david_ten
5,480 posts
 
@jcarcopo  Thanks so much. Your reasoning and choice are so very clear now. Super helpful for my understanding. As an aside, I did not realize that the XA 25 had the 'highish' damping factor that it does. 
jcarcopo's avatar
jcarcopo OP
501 posts
 
@david_ten Yes, actually all of it's specifications are superior to the more expensive XA30 and higher amplifiers.  I assume it's because he uses only 4 large power transistors per side in a slightly different way in the XA25's. 
sid-hoff-frenchman
50 posts
 
Yes, I can report that the monoblock Aegirs have powered the Encores without any problem, until today. I was playing a the Taiko group Kodo's album Ibuki and had the volume up to about 85-90 DB. This is a really bass-frequency-heavy album, and the biggest impedance needs happen in the bass region. After a while the Aegirs started briefly going into protection shut down. The album was fine at lower levels, and everything else I've played the Aegirs have been fine with, even at equal volume levels. I will still try out other pre-amp and amp combos down the road, but so far so good. 
jcarcopo's avatar
jcarcopo OP
501 posts
 
@sid-hoff-frenchman Another good one is Yim Hok-man "Poems of Thunder". That 10 minute track will put my Pass Labs XA25 into protection if I turn my DAC's volume up to -3db which, to be fair, is nearly wide open. So big Kodo Drums 🥁 really strain my amp at high volume as well. I consider this quite acceptable and normal considering it's a 50wpc Class A amplifier. Other than that one track I've not really had an issue except like twice on very high gain and dynamic recordings that I was playing way too loudly in the first place. 
sid-hoff-frenchman
50 posts
 
@jcarcopo That's good to know. I guess then the Aegirs are performing on par with similarly powered amps. I wonder if the protection is being triggered by impedance dips, or wattage needs?
More to discover