Audiosilente idler wheel versus Artisan Fidelity idler wheel for a Garraed 401
Material - Austenitic Stainless Steel CNC machined case hardened CNC ground inner coupling pin, near true zero measured radial run-out. State-of-the-Art CNC/CAM Machining achieves ultra close tolerances and accurate concentric form. Heavy weight enhances flywheel effect.Periphery Outer Drive Material - Concentric, Molded Seamless Rubber based Composite, precision CNC ground, near zero measured axial run-out. Manufactured as direct OEM Garrard 301 Schedule I & II / Garrard 401 / Garrard 501 Model replacement part.
The Audiosilent is aluminum with a square rubber outside ring.| Post removed |
| Post removed |
@dangcaonguyen @vetterone @lewm @noromance Thank you All, I have ordered the AS idler wheel with brass bushes. Simone (from AS) asked if I would like to order the brass bushes for the motor too. Any opinions? Thx again, |
If you know how to take the motor apart to lube the lower bearing, it can’t hurt having a replacement bearing on hand. If the table is used and new to you, figure on doing the above as a matter of essential maintenance. The most difficult and real PITA bearing in the 301/401 is the lower idler bearing. Be real careful working on it when you swap the new AS in. If the lower spindle is wobbling in the bushing, you will have real bad sound. Replacing the bushing requires some skill and tooling. |
@noromance Thank you for your recommendaiton. The AS idler wheel arrived today. I have installed it and seems to make a slight 'whirr sound' but it sounds great. Especially. in the mid range. Also more dramatic/faster articulations/dynamics. I haven't installed the bushes. It looks tricky. The existing upper bushing is firmly in place and I'm not sure how to remove it without some pressure. Is there are good way to do this or does it normally come out easily? May be there is some tutorial/ video available somewhere? Thank you, |
