Upgrading speaker cables...

Do not listen to the naysayers, cables make a difference, experiment and judge for yourself.

@manofgteelpt,

What I meant is if you have bare ended wires, to try what I suggested. I can’t recommend stripping off cable ends if it’s not in your budget but if you’re of a mind to try, what I suggested is to use the positive cable end to connect to both positive speaker posts and the negative end to their corresponding speaker posts (using just one set of cables, not two).

Both pos and neg speaker binding posts should be directly above each other. Don’t cross them. All you’d be doing is using one cable to reach both of it’s corresponding posts. The length of bare wire needed should be no more than 3 inches to reach both terminals.

Try removing the speaker post caps and see how the eye of the post is oriented, and thread the cable through the bottom post and connect it the same way to the upper post. It makes for a clean and tidy connection. You’re basically threading two needles.

All the best,
Nonoise

I agree with Shadorne that fancy cables will not make a difference other than to your bank account, nor wil bi wiring. If they do, there is something wrong with either the cables, the speakers or the amplifier. Fancy cables are just great money makers for the industry, with huge margins. Do make sure the cables are thick enough for the length that you are using.

" If they do, there is something wrong with either the cables, the speakers or the amplifier"
That is just silly talk, experiment and judge for yourself.

Agree with dill

I don’t understand how good audio gear will produce finely detailed sound based on sensitivity to minute changes in the signal yet not be sensitive to differences in the electrical properties of various brands of wire unless "broken".

Again, as dill says, experiment and judge for yourself.