Granny ring, Jetrexpro, all

Jetrexpro,
It is a wonderful happening when you get to your state of satisfaction with an audio system. I'm there with my second/office system. After changing out the stock capacitors for Arizona Green/NOS stock Mallory capacitors and select Ohmite Brown Devil resistors plus WE wire all suggested by Yazaki-san and replacing all the stock tubes, Oyaide wall outlets and plate I believe I am done, save for experimenting with the Synergistic Red or Black fuse. Then
the only other temptation is to up the ante and acquire new speakers? But that will require a much larger amount of cash to top what the Tekton's do. I find a lot of satisfaction in putting together killer second system that compares or beats much of the high price stuff. This particular set-up I have does that. Best, Rob

Agreed Rob. Nice to hear that you are enjoying your 2nd system and its great to use DIY to upgrade caps and resistors to get to that place. Money savings for sure!

Jet - I am using slightly modified Klipsch LaScalas (aftermarket crossover and tweeter(s).  I use WE 14ga to wire the midrange to the xover and WE 16ga for the tweeter.  I have tried other wires but am liking the balance with the WE so far.

I tried the WE 16 for the speaker wires (bare) and have had them in and out.  I will try them again sometime.  I have some Rhodium/copper spades and some gold/copper bananas I could try as well.  I may not even bother with the WE 10ga for the 2A3s.

I made a PC for the DAC with WE 14ga for the H/N and a piece of 8ga wire I had laying around for the ground.  I used these connectors: 
http://www.sonarquest.net/carbon-edition/rhodium-plated/sonarquest-carbon-fiber-series-rhodium-plate...   I take it out periodically to try something else; but I keep putting it back in!

I have all of these projects in mind for the WE wire I have.  The only stumbling block is the execution.

Thanks Maxima95. Hope you do try the 10ga WE wire to see if you have the same results as I did. The 2a3 tube is less warm than the 300b so you might have different results. Guessing that your 2A3 amp sounds great with the Klipsch LaScalas.

I have purchased WE10GA for the power cords. I saw on this forum somewhere building guide of the the power cables. Have someone a link for a good building guide of the cables?
And I have WE10GA in pair lengths , can I use for the ground wire normal copper AWG10-8 cord for the ground , or is there a advantage of using same WE10GA ? I have some WE14GA leftovers if its necessary.

I want to use this on my Pass XA160.5 , Pass XP20, DAC la Scala MKII