Ideally the bearing of the tonearm should be at the same height as the LP surface, otherwise there will be changes to VTF as the cartridge goes up or down with record warps. The greater the vertical distance between tonearm pivot and LP surface, the greater the magnitude of the VTF modulation. The same thing is true for the tonearm's center of gravity, which, if changes to VTF as a function of height are to be minimized, should properly be at the same height as the LP surface.
VTF modulations as a function of cartridge playing height will then cause the angle of the signal coils to change within the field of the magnetic gap, and the SRA to change. Both can be a source of non-linearities or IMD.
Whether the changes in SRA will be audible or not are partly down to the stylus profile - usually a long-footprint line-contact stylus with a narrow side radius will be most sensitive, while a conical may not be sensitive at all.
The change in coil angle with VTF may or may not be so clearly audible - it depends on the cartridge. The reason is that with most cartridges, there are two different VTF "sweet spots", one higher, the other lower in value. The lower value VTF sweet spot will align the signal coils so that they are parallel to the magnetic gap, which gives best linearity (which may or may not be the same thing as maximum output), and the most equal values for horizontal and vertical compliance. However, the lower value VTF will usually not be sufficient for optimal tracking of the LP groove.
The higher value VTF sweet spot will allow optimal tracking of the LP groove, but will push the coils out of alignment with the magnetic gap.
This is why you typically see a quite large recommended range for VTF from the cartridge manufacturer - the wide range signifies that a compromise between two different requirements is occurring.
OTOH, a cartridge that has been designed so that the VTF value which aligns the signal coils to the magnetic gap coincides with the value required for optimal tracking, will have a quite narrow recommended VTF range from the manufacturer.
hth, jonathan carr
VTF modulations as a function of cartridge playing height will then cause the angle of the signal coils to change within the field of the magnetic gap, and the SRA to change. Both can be a source of non-linearities or IMD.
Whether the changes in SRA will be audible or not are partly down to the stylus profile - usually a long-footprint line-contact stylus with a narrow side radius will be most sensitive, while a conical may not be sensitive at all.
The change in coil angle with VTF may or may not be so clearly audible - it depends on the cartridge. The reason is that with most cartridges, there are two different VTF "sweet spots", one higher, the other lower in value. The lower value VTF sweet spot will align the signal coils so that they are parallel to the magnetic gap, which gives best linearity (which may or may not be the same thing as maximum output), and the most equal values for horizontal and vertical compliance. However, the lower value VTF will usually not be sufficient for optimal tracking of the LP groove.
The higher value VTF sweet spot will allow optimal tracking of the LP groove, but will push the coils out of alignment with the magnetic gap.
This is why you typically see a quite large recommended range for VTF from the cartridge manufacturer - the wide range signifies that a compromise between two different requirements is occurring.
OTOH, a cartridge that has been designed so that the VTF value which aligns the signal coils to the magnetic gap coincides with the value required for optimal tracking, will have a quite narrow recommended VTF range from the manufacturer.
hth, jonathan carr