2. speakers
  3. 1205647150

Which speakers will fill 5,000 cubic ft coherently

In porevious threads I've bemoaned the fact that my Kharma 3.2 FEs don't fill the room, 17 X 23 X 15 ft ceilings with a vertical enough soundstage, as though the speakers are literally too small. I have been advised to raise them,which I have done, , I have told to get taller, line arrays, even given names of custom speaker makers. Any specic recommendations from those that have had, and have conquered, this issue.
springbok10

Showing 2 responses by jj2468

jj2468
280 posts
 
Get somebody to take a digital photo or two and post your system with the photos on agon under member systems. Given your limitation of 18" in your large room, you may have a setup issue that could benefit from some helpful agon member comments before you can make any convincing loudspeaker assessment.
jj2468
280 posts
 
Ralph's advice about no less than 6 ohms and preferably not less than 8 ohms is right.

I've tried the Speltz autoformer. Although I really like the speltz cables, I do not recommend the autoformer. I've tried it. I believe it exists as a band-aid for those who have an amp/speaker mismatch and it may be helpful in that context. It does, however, introduce problems of its own. IMHO, a seller who recommends buying a 4ohm speaker and the autoformer to go with the Atma is doing a disservice.

Again, with a room that large, why are you limited to a 10" speaker width? Maybe I am misunderstanding the situation, but any of these speakers need breathing room around them and you have a big room.
More to discover