Which resistors to use for KT88 output tubes

I was thinkin Mundorf for 10 ohm and Mills for 100 ohm. Isn't Rinken carbon? I'm kinda suspicious about the reliability and stability of carbon resistors. What's a good metal film resistor for 2.2kohm.

Although Mundorf and Mills claim theirs are noninductive, I would like them to provide inductance value. Reason being, inductance in this application could cause oscillations from what I've read. Is this a concern?

Wont metal film work just as well on the grids?

Hi Rodman, I don't see any mention of wirewound resistor being quieter than Vishay or Caddock in the link you provided. Is this from your personal experience?

Wont metal film work just as well on the grids?

Thanks Rodman. I read it again and saw the reference to wirewound resistors.

Based on the schematic of my KT88 amp, I see a 2.2 kohm 2 watt resistor to the control grid, a 100 ohm 5 watt resistor to the screen grid, and 10 ohm 5 watt plate resistor.

Obviously, the 10 ohm resistor should be a wirewound resistor. It will probably also be noninductive as well.

The control grid resistor should be a noninductive wirewound too.

It is the screen grid resistor that should be carbon comp because of its low inductance? Why can't I used a non-inductive wirewound resistor here?

PRC makes very high quality precision wirewound non-inductive power resistors.
http://www.precisionresistor.com/files/PDF/Precision-Power-SM-Series-Wire-Wound-Precision-Resistor.pdf

Thanks, Rodman. I Mills and PRC power resistors seem to be perfect for the job.