2. analog
  3. 1223879515

When cantilever not parallel to cartridge sides


A newbie question:

I have only bought two new cartridges so far and found that in both cases, the cantilevers are not parallel to the sides of the cartridge bodies. In both cases, I have to twist the cartridge bodies by 20% or so in order to properly set the correct zenith angle.

I wonder is this normal? or should I send it back to the dealer for exchange?
viper_z

Showing 3 responses by viper_z

viper_z OP
95 posts
 
sorry again.. reposting the link to the picture I refer to in my previous post:
http://farm4.static.flickr.com/3192/2939007240_2c2fbfc260.jpg
viper_z OP
95 posts
 
All,
I am very very sorry.. Pls accept my apology. I meant to say that the angle is about 20 DEGREES off! (Not 20%!).

Please allow me to attach this picture below, please click on it and see if this cartridge alignment is normal.

http://www.flickr.com/photos/9358823@N02/2939007240/

Thank you all.
viper_z OP
95 posts
 
Thanks guys.. sounds like I do have a case to ask for an exchange!!
More to discover