2. analog
  3. 1332210860

What's next after Dynavector 20XL?

I haven't heard and don't have audition access to the many fine cartridges mentioned in this Forum so I'm hoping you can help. I would like to move up a step or two from my current cartridge, but keep the budget to about $1,500 or less.

I like the character of the Dynavector 20XL as described in a 6moons review: "The DV 20X-2 brings more openness to the midrange without grain or stress, tremendously greater treble extension and information and a little more control in the bass. It also stages deeper and images more precisely whilst delivering almost all the dynamic impact of the Denon. The 20X-2 is not a warm cartridge but I doubt anybody would describe it as cold or analytical as you'll read about some older Lyras now and then. Neither does it offer the rich density of the better MM options but it certainly delivers the best of MC resolution and tonal finesse with a huge helping of giddy up."

One area that I would like to improve upon is tracking ability (some highly modulated grooves have caused mistracking).

What would you suggest as an upgrade?
kencalgary
inna
7,296 posts
 
You didn't mention your table/arm/phono.
kencalgary OP
45 posts
 
Inna, my system is almost all DIY or modified but here goes. I am using a modified Technics SL1210 with a stock arm that has been re-wired with Cardas and internally damped. The phono interconnects have also been changed to custom, low capacitance high quality OCC silver. I have the KAB fluid damper. The tube preamp (NOS tubes) is based on John Broskie's Tetra (phono) and Aikido (line) circuits. My tube amp is a Bob Latino ST-120 Dynaco-clone. Cables (interconnects, power) are also DIY.
onetwothreego
54 posts
 
You say you would like to improve on tracking ability, but the cart you have, (Dynavector 20XL with Microridge Stylus) is pretty much the ultimate in stylus tip technology. It doesn't get any better. What that means is, you are now hearing your table and arm when you hear distortion, not the cart. It has nothing to do with audio snobbery, but put that cart on a table with better motor/arm isolation, and you will find it tracks anything you can throw at it without breaking a sweat.
inna
7,296 posts
 
I think, I agree that arm and probably table too should get the attention first. $1500 is not little money especially when buying used. Yeah, you could consider re-evaluating your entire analog rig. I certainly would.
kencalgary OP
45 posts
 
Thanks for the useful information.
More to discover