what's causing a SME 3 to stick after a few spins?

It sounds like the arm lift isn't retracting quite far enough.

Leisual, you're getting warm, but please try the string technique as it's the more sensitive then the "gently pushed" method ;--) I think changing the cart is a good idea just to eliminate that possibility (leave no turn un-stoned ;--) however I'm not optimistic :--(

Then post your findings and I can at least give you my advice for what it's worth ;--)

Neil

> Does this occur with the AS turned all the way off?
> When it 'skips', does it skip toward the center or outside edge of the record? Or rather, by 'skip', do you mean it won't track (keeps playing the same groove over and over again?)
> What Sutherk asked -- does it resist horizontal travel when the stylus is slightly above the record. You can check this by looping some thread under the TA wand near the headshell, and with the lifter down, AS off, stylus guard in place, hold the thread in one hand suspending the cartridge end of the tonearm just above the platter, and holding the thread, try gently moving the arm across the platter in both directions. If the horizontal bearing is seizing, you'll know right away. Are you the original owner?
> As far as I know, the only silicone damping in that arm is in the lifter mechanism, and the swiveling DIN plug. So I can't see how any would get into the horizontal bearing?

Leisual -- Did you change the cartridge too? I wasn't betting on the cartridge, but it's worth taking the time to rule it out. That said, (and for what it's worth ;--) here's what I think (and I truly hope I'm wrong) but I believe there's a problem with the horizontal bearing. If so, it could be (hopefully, just one of) several possible things.

OK. I could go on. I know a hell of a lot about SME arms. But as an end user, not as a repair specialist. So even though there are a couple of more things I would try if it were MY arm, it's NOT my arm, and if I were right (about what I think the problem actually is) neither of us would be able to fix it anyway! Instead I'm going to give you info for the TWO BEST PLACES someone with a Series III should contact. I recommend you contact them both simultaneously. But because you have a Series III you'll probably wind up working with the folks in Canada, rather than the factory in the UK:

1.) Brian Laker in the service dept. at SME service@sme.ltd.uk Put 'attn: Brian Laker' in the subject line and explain what you tried/know so far. I've had extensive experiences with him from arm rewires to help with parts purchases and setup recommendations. He's been very accomodating.

2.) SME3009 Tonearms: http://www.smetonearms.com/ These people are great! In some respects better than the factory -- not in quality, but because they restore older arms, do upgrades, etc. If you send your arm in for a rewire, for example, you'll get it back completely refurbished and tested, with all original factory accessories including a new Owner's Manual! Browse their entire site but start with the 'About Us' page and you'll see what I mean. Again email (or better yet call) them and explain where you are at ths point.

I'd appreciate your getting in touch with me or adding to this thread when you find out what the trouble is.

Neil
.

Leisual, I'm happy that things seemed to resolve on their own. If it were me, I probably couldn't just let it go at that, and I'd still want to know what caused the symptoms in the first place, but that's me ;--)

In any case, should the problem return, I would suggest you get in touch with the other people I mentioned http://www.smetonearms.com (or maybe you already have?) because they do service, and even restore those earlier models.
.