2. amps-preamps
  3. 1214946514

What happened to my SET amp?

Hey all,

I was playing my Dared 845 SET integrated amp today, and after about 10 minutes, I noticed it had quit playing, the power lite had gone off, and it was smoking like hell from the lower-back of the amp. I pulled the fuse at the IEC and it was blown (thankfully!). It was marked as 125V/8A.

Nothing has changed since I've originally hooked it up about a month ago and it has played properly for hours at a time since then.
Any ideas what might have happened?
I appreciate your comments.
Good Listening!
myraj
atmasphere's avatar
atmasphere
11,676 posts
 
There was an **8 Amp** fuse in it??!

The fuse was **way** too high a rating. Pack the amp up and send it back for repair.
myraj OP
351 posts
 
Yap, the fuse was marked 8A.
I'll be sending it in for service.
Thanks for all your comments!
And...........Good Listening!
jakester99
6 posts
 
The Antique Sound Lab Leyla 845 DT uses a 10 amp, slow-blow fuse and it is spec'd similarly to the Dared VP-845. Am I right in guessing that this amp uses a similarly overrated fuse?

What would be the correct value for this fuse if not in the 8-10 amp range?
atmasphere's avatar
atmasphere
11,676 posts
 
I would check with the manufacturer, but IMO the fuse rating with an amplifier like this should be set (not pun intended) to be just slightly above the AC current draw that the amp has after one hour of operation. You'd have to find that out with an AC amp meter so unless you have the equipment, it may not be that easy to sort out.

One fuse controlling two channels complete with filaments might actually be that high. It would not give you a lot more than just fire protection though. I guess I am used to using a few more fuses in the amp to give greater protection.
More to discover