Warm up time for amps


My amps ( I have many but as an example in this case Bryston 7b3's) seem to take a good 45 minutes to reach best sound. My question is ... how do I warm them up quicker? Is playing them on a revolving loop or shuttle BEFORE my listening starts the only option? If that is the case does playing at low volume achieve the same results, and/or does playing louder speed things up, and if so presumably the louder, the quicker in proportions?
And in that box, is the ambient temperature (eg summer or winter) a factor? To me, it should make no difference with all that stuff going on inside a confined space,  but someone will tell me otherwise? I could rig up small fan heaters to blow for ten minutes? If it cuts down warm up time by half for example it may not be such a  stupid or strange idea as I think it might be, as it would increase the proportion of "enjoyable" listening time substantially.
I could even be super smart by putting timers on the fans (which in case anyone points out a supply contamination issue ... could be on a different circuit entirely
The amps are rarely switched off.
This issue does frustrate. All that expensive kit not performing at best for a period ....
tatyana69

Showing 1 response by dobnbav

This is absolutely normal.  You would think of divesting in an amp because you are using it wrong and are uneducated on the subject of mechanical settling? Solid State should ALWAYS be left ON, unless you are traveling for an extended period of time or you're expecting lightning. Tube amps also do NOT just come on and become listenable instantly. Just like tubes need to warm up and settle, so does your Bryston. Why would you presume a fan cooling your amp would aid in it's settling? It gets better sounding as it WARMS up not cools down. Ever notice no one in a sporting event cools down first? No they warm up. Your idea that a case somehow impacts the the electronics is also demonstrative of you're having it all wrong. Do you own a car? A sports car perhaps or a Porsche for instance? The user manual specifically states it is dangerous to the engine if run over 4100 RPM before running for 5 minutes and that one should not sit idle too long when initially starting up.The circuit it's on has no bearing.  Keep your amp on and idling all the time. Your preamp too. Chill and don't be in such a rush. The tortoise always beats the hare.