WA-Quantum GmbH's Quantum Chips

I was living on the edge for years,using DIY fuse replacements.
When the Iso Cleans came out I tried them and they were better than stock and much safer than DIY chunks of wire.

Then when the HiFi supremes came out I didn't hesitate to try them in my old Acoustat servo charge tube amps.

Very nice improvemnt over the stock fuses, which may have been original.

Only when I applied the WA chips did fuse directionality become audible.

What else became more audible was the improved weight to the music when the fuses with the chips were in the right direction.

In the opposite direction the sound was more lightweight and tipped up towrds the upper frequencies.

Anyone tried the chips on stock fuses?

So far I don't seem to have seen any posts.

The cost for the fuse chips is dirt cheap, so I can't understand why those who feel the designer fuses are too costly, would not try the WA chips on their own stock fuses?

Placing a WA fuse chip on top of one end of a standard fuse did make an audible improvement.

I took out a pair of Supremme fuses I was using in my Acoustat servo amps and re-inserted the two stock fuses without the chips.

The sound was less focused and a bit shrill.

Adding the WA chips to the stock fuses improved the sound,and made the stock fuse sound more like the sound the amps had with the Supreme fuses.

Sounds too good to be true doesn't it?

I then took the chips off one amp only and listened.

The sound of the amp without the chips again sounded more grainy, less smooth than the amp with the chips.

I was about to try the Nano fuses,but I think I'll quit where I am at and enjoy the sound as it is.

This has to be the cheapest ,most effective tweak I've ever experienced.

The chips work with the AMR Gold fuses,took them off the Supremes and notice similar improvement to sound.