I have a VPI Scoutmaster sitting on a Ginko Cloud 11 but I also use Blu Tak under the motor. Works well.
VPI table isolation
I have a VPI Aries table with a Scout motor (long story) setting on top of a Polycrystal rack. As I was making some adjustments tonight, I noticed that when I touched the arm, I could feel the motor vibration. I disengaged the motor from the platter while running and could still feel the vibration.
Any recommendations on how to isolate the motor from the table? I do not want to spend more than $400-$500 as I am not sure how long I will keep this table, but if I could make an improvement, I would do it.
Any ideas would be appreciated
Any recommendations on how to isolate the motor from the table? I do not want to spend more than $400-$500 as I am not sure how long I will keep this table, but if I could make an improvement, I would do it.
Any ideas would be appreciated