2. analog
  3. 1263584319

VPI Single Motor Flywheel / SDS / Aries 3

I just purchased a new VPI Single Motor flywheel for my Aries 3. I have an SDS. It seems like I get answers a little quicker from this forum than VPI, although I have a call in to them.

Here is my dilemma: When I have the Single Motor Flywheel plugged in to the SDS or the wall outlet, the motor turns the flywheel too slowly and I am several HZ below the 60Hz/33RPM on my SDS. The sound is very slow and clearly under 33 rpm on the platter. The flywheel seems we lubricated and turns easily. The motor is quiet. It's just slow. So slow, I have to turn the SDS up to 65-66 HZ to approach strobe disc accuracy and acceptable sound for 33 rpm. Haven't even tried 45 rpm yet.

The motor is placed within proper distance to the flywheel. It came with two small brown belts for the motor to spin the flywheel and one larger black belt which appears to be the same size as the belt used on the Aries 3 regular 300 rpm motor.

Is this normal? Anyone with VPI single motor flywheels or experience with them that could give me advice would be greatly appreciated.
philb7777

Showing 1 response by tobes

tobes's avatar
tobes
436 posts
 
Philb7777, I haven't got your pulley but I think you'll find 2 hex grub screws on either side of the pulley near the bottom.

Simply loosen the hex screws and the pulley will slide off. Put in the replacement pulley and evenly tighten up the grub screws on the new pulley.

Regarding the SDS voltage.
I use the original 20lb(?) acrylic/lead TNT platter with the single motor/flywheel. I also used two belts between the motor and flywheel and 2 belts between the flywheel and platter - because it sounds better IMO. However, turning that heavy flywheel, platter and 4 belts is perhaps too much for the single motor used at 72V (which no doubt reduces the torque of the motor). The motor will do it, but some bass impact and speed appears to be lost. This may be why Harry went to the dual motor setup with the Scoutmaster/TNT-6/HRX.

In any case, I use the SDS set to 115V with my single motor/flywheel setup and find the sound much 'snappier'. I can't detect any increase in noise - if anything the the motor appears to be running smoother (to the finger test).
It may be worthwhile trying the higher voltage settings on the SDS to see if you derive any benefits.

System Details
More to discover