2. analog
  3. 1323104535

VPI Rim Drive vibrations

I have VPI SSM with RIM drive and SDS. The issue I'm having is a vibration being transferred from rim to the desk/platter. As the result tonarm wobbles a little bit in azimuth plane.
I tried to replace the brownish rim belt, change contact force/distance between the drive and the platter, and reinstall the belt - the vibration still there (exactly one wobble per rim's full revolution - 360 degrees).

The speed stability is very good though - have checked it with KAB Speed Strobe.

Any ideas how to resolve the issue?

Thanks a lot!
krell303

Showing 1 response by dougdeacon

dougdeacon
3,338 posts
 
Krell303,

If you need to isolate your TT from the floor yet also need it holding rock steady vis-a-vis the motor, the obvious solution is to place both TT and motor on a single platform, then isolate that from the floor. Vibraplane, Symposium shelf, Minus-K, a DIY or whatever.

Two engineering requirements, two solutions.
More to discover