2. analog
  3. 1350320370

VPI Platter Spinning SLOWLY

I've tried two different lubricants (Super Lube and Shimano Dura Ace Grease) for my VPI Classic 2 platter and it still does not spin properly. I removed and re-applied grease and it spins fine for about 5 minutes, then it slows down immensely. If I remove/re-install the platter, it spins smoothly again but only for a short period of time. Anyone experience this before and know a fix? Thanks
jyoungpark

Showing 5 responses by jyoungpark

jyoungpark OP
17 posts
 
@Pbnaudio
What is your method for pulling the bearing out to access the well?

Thank you all for the suggestions.
jyoungpark OP
17 posts
 
The belt is slipping but only because the platter is seizing.
jyoungpark OP
17 posts
 
@Brf
Just a dab. Then I distribute the grease around the bearing and on the spindle.
jyoungpark OP
17 posts
 
I removed all the grease from all the components, including the platter, using a combination of alcohol wipes and isopropyl alcohol. Applied a small dab only to the bearing, and re-installed the platter. Once it set, I think it was harder to turn than before.

Would VPI be open to me bringing the TT to their shop in NJ to take a look? I'm in NYC so it's doable. I contacted them this morning around 9AM and still no response.
jyoungpark OP
17 posts
 
Taking the table into VPI tomorrow! Thanks for all the responses
More to discover