2. analog
  3. 1220652099

VPI Headshell weight question

So based on a recommendation from Harry (VPI), I purchased the 3g headshell weight for my Scoutmaster/Shelter 501MKII. It didn’t come with any instructions and it’s not obvious how to install it. Does it go between the headshell & cartridge or attach to the top of the headshell?

Also: I assume I re-adjust VTF so that it’s still within recommended range (i.e. Shelter manual) or is the whole point that I need to go over by 3 grams?

Thanks…
madfloyd

Showing 2 responses by ckturtle

ckturtle
17 posts
 
I'm also in the process of adding a 3 gram headshell weight to a JMW 9 arm.

I found that by placing the weight between the cartridge and the headshell had caused the rear of the arm to be far too high (after VTF adjustments) to the point where the stylus lift bar, adjusted to its highest setting, will not even be high enough to lift the arm off the record.

I'll have to go back and place the weight back onto the headshell.
ckturtle
17 posts
 
Yeah, I thought it was strange too. I went back and redid everything. The weight is now under the headshell and the stylus lift bar is working fine.
More to discover