2. amps-preamps
  3. 1366075045

Volume control upgrades-

I have been into this hobby for over 25 years. I just completed my 3rd volume control upgrade on a preamp and was reminded just how much of a huge upgrade it is. By far, I feel the most significant upgrade one can do, regardless of cost.

This time I used a Goldpoint attenuator, which cost $150. I added a Bent Audio remote control system for $200. Labor was $200. Just incredible. The preamp had a standard $5 volume pot in it. In the past I have used TKD stepped controls.

I am now at the point that this change is an essential one.
Thought I'd share with others as it really is a low cost upgrade.
128x128justlisten
ivan_nosnibor's avatar
ivan_nosnibor
1,047 posts
 
Using a pair of Goldpoint SMD (balanced) attenuators installed directly at the backs of a couple of Monarchy SM-70 Pro's...performance-wise, I haven't since even thought of ever buying another preamp, no way...AND it's a fraction of the cost.
rgs92
974 posts
 
I replaced my DACT 23-stepper with a TKD 2500 continuous attenuator and love it. I did this because I could not get a precise enough level with the stepped DACT, but I am pleasantly surprised at the resolution, solid bass, and more organic less piercing lower treble (but still pristine upper highs) of the TKD.
Just sharing my experience.
jeffjeremy
2 posts
 
Would anyone care to recommend a dual volume attenuators upgrade for a first generation "Audible Illusions Modulus Tube Preamplifier with MM Phono Section". I know this would definitely be a very good simple upgrade for this wonderful hybrid early generation preamp...

Just need the nomenclature/design elements of the parts I need, my knowledge in this area is nonexistent. But the setup I will be useing could benefit quite alot from this type upgrade as I understand.

Thks Jeff
PS I will not hold any recommendations against the overall success of this project.
syntax's avatar
syntax
2,193 posts
 
Yes, Poti is essential, the signal goes through it. Normally the signal looses a lot of its quality based on cheap design (material ---> signal transfer ability) But before, it will reach the Preamp via its $6,95 RCA connectors. To replace these is even more important with High quality units (Eichmann Phono Pods for example) ....
csontos
1,311 posts
 
Why not go all the way and just get a Lightspeed Attenuator?
More to discover