2. amps-preamps
  3. 179151-175721

Voltage divider/attenuator

I have a 10V audio source that I want to bring it to line level 1V. That’s pretty easy: I just need to use a voltage attenuator 10:1 like image below. I used resistor values of 1k ohm (R1) and 100 ohm (R2) and it worked great! BUT I have a question: what if I had used 100k and 10k ohm resistors? The ratio is still 10:1 but I think it would not produce a good result (I have no idea why I think so).

 

Would you please tell if I am right? If so... should I use 100 ohm (R1) and 10 ohm (R2) resistors instead of 1k ohm and 100 ohm that I am currently using? Would it be a good idea? I just want to bring this 10V speaker level to line level and so far using 1k/100 ohm worked fine (no noise, no humming...)... but I am wondering if I am doing it right... should I try different resistor values (keeping the same ratio, of course)?

 

batata004

Showing 1 response by rodman99999

rodman99999
6,206 posts
 

     Regardless of the examples you’ve mentioned; with 10V in, you’ll end up with .909V out.

     Seems to me: the use of 50 (R1) and 12 (R2) Ohm resistors, giving a 1.94V output, would yield better results (sonically), 1V being kind of wimpy, far as line level.

     Multiplying those two values by 10, 100, 1000, etc, will still yield 1.94V.    Will that affect sonics?    That’s why we experiment.

     Use either wire-wounds or metal films, for the least coloration.    ie: Vishay makes some very nice ones

More to discover