2. analog
  3. 160855-86984

vinyl versus digital redux

Has anyone compared the sound of vinyl with the sound of digital converted from a vinyl intermediary ?

I am referring to 'rips' of vinyl made with high end, high quality vinyl playback systems, with
conversion to high resolution digital.
I find it nearly impossible to distinguish the two results.
The digital rip of a vinyl record sounds identical...or very nearly so...to direct playback of the vinyl.

If one has 'experienced' the foregoing, one might question why digital made without the intermediary of vinyl sounds so different from vinyl.   A detective story ?

We are talking about vinyl made by ADC (analog to digital conversion) of an amplified microphone signal and re-conversion to analog for output to the record cutting lathe, or from analog tape recording of an amplified microphone signal, and then....as above...via ADCl and back to analog for output to the cutting lathe.

Of course vinyl can be and is 'cut' (pressings made from 'stamper' copies the 'master' cut in lacquer) without digital intermediary.  Such practice is apparently uncommon, and ?? identified as such by the 'label' (production)

Has anyone compared vinyl and high resolution digital (downloads) albums offered by the same 'label' of the same performance ?  Granted, digital versus vinyl difference should diminish with higher digital resolution.   Sound waves are sine waves....air waves do not 'travel' in digital bits.    A digital signal cannot be more than an approximation of a sine wave, but a closer approximation as potential digital resolution (equating to bit depth times sampling frequency) increases.

If vinyl and digital well made from vinyl intermediary sound almost identical, and If vinyl and digital not made via vinyl intermediary sound quite different, what is the source of this difference ? 

Could it reside....I'll skip the sound processing stages (including RIAA equalization)...in the electro-mechanical process imparting the signal to the vinyl groove ?

Is there analogy with speaker cone material and the need for a degree of self-damping ?
Were self-damping not to some extent desirable, would not all speaker cones, from tweeter to sub-woofer, be made of materials where stiffness to weight ratio was of sole importance ?

Thanks for any comments.
seventies
seventies OP
67 posts
 
Cleeds, bluemoondriver, 
Apologize if I did not clarify.
I concur that lp's newly made from tape or high resolution digitalization of an audio source can be 'very close to the master tape' except that 'cutting the spiral groove' (what I termed an electro-mechanical process) changes the 'original sound' in a manner pleasing to some listeners.
I am asking about LP's made decades ago from analog tape...whether these lp's preserve sound...particularly high frequency sound...better than does the tape itself.
Regarding possibly 'misleading commercialization', I refer to 'high resolution digital transfer'...ie transfer from tape... and 'digital re-mastering of tapes recorded decades ago....before high resolution digital recording became available.
One company, 'High Definition Tape Transfers' (HDTT is their logo) offers downloads in a choice of digital resolution.  To my ear 'high resolution' is a specious claim insofar as one is making a high resolution digital copy of a time-degraded source....ie. low resolution in particular respect of lost high frequency information.
Digitally "re-mastered" tapes from that era, also sold as downloads or streamed, and sometimes not identified as 'remastered', are subject to the same loss of initially recorded information.  Resolution is not and cannot be improved by boosting the treble.
Am I misleading ?


orpheus10
8,668 posts
 

It's hard for me to understand other people's problems because I don't have any.


Just about the time CD's came out, I was buying LP's like crazy. CD's "appeared to be" superior to LP's, so I went exclusively into CD's, leaving all my new LP's going unplayed. (I had the same kind of record player we all had back in the day) A CD and CD player was, and still is clearly superior to that rig.


Not until many years later was "high end" analog revealed to me; it wasn't the record, but the "record player". Back in the day, we spent $200, for TT, and 60 to $150 for cartridge; that was common. You know what's common for our analog rigs now, a lot more than back then, plus they are many times more complex, no wonder records sound better.


"I am asking about LP's made decades ago from analog tape...whether these lp's preserve sound...particularly high frequency sound...better than does the tape itself."

The LP sounds good, but never better than the tape.


As a result of not playing all those old records after purchase, I have many new LP's that were purchased back in the day. Just yesterday, I down-loaded "Azymuth Spectrum", recorded in Rio Brazil 1985, and I must have purchased it about that time; this album is dead silent. That's representative of many of my LP's. I can't answer questions about these new processes.
ericseaberg's avatar
ericseaberg
3 posts
 
I was mastering lacquers for vinyl in the late 70s to early 80s and my current turntable is a ReVox B791 tangent tracking system, playing vinyl EXACTLY as it was cut... straight across the middle. No groove distortion or side-to-side phase errors. 
I use a Ortofon VMS20e cartridge I purchased in 1985 and have a store of new styli as needed. 
Preamp is by Graham Slee feeding an RME interface where I transcribe into ProTools at 96kHz/24bit minimum. Conversion is done to 44.1/16bit for my old clients that have lost master tapes, allowing the to do CDs as needed. 
There is something magical that happens between the groove, stylus and preamp that is hard to compare with digital transfers of the master tape. In many cases, I will purchase 96k or higher files of albums even though I have a great vinyl copy... and they do sound different. 
Just my $.02. 
ericseaberg's avatar
ericseaberg
3 posts
 
I am asking about LP's made decades ago from analog tape...whether these lp's preserve sound...particularly high frequency sound...better than does the tape itself.
Regarding possibly 'misleading commercialization', I refer to 'high resolution digital transfer'...ie transfer from tape... and 'digital re-mastering of tapes recorded decades ago....before high resolution digital recording became available.

When I was recording to tape in the 70s to late 80s prior to Digital, our multitrack tape machines were capable of HF response above and beyond 23-24kHz, with SN ratios approaching 70dB, depending on tape format and speed.  

One of the projects I did in the mid-80s was mixed to ½" analogue tape at 30ips as well as DAT tape 48kHz/16bit.  There was NO comparison to the sound and we stuck with the analogue tape, transferring it to DAT once the final mixes were edited & assembled for mastering. 

Many of the early CDs were mastered using what was called an EQ COPY of the master tape, taking into consideration EQ and processing for mastering to vinyl and NOT from the original master tape.  It took several years for companies to REMASTER for CD using the original tapes and not use EQ copies.

That being said, since there was a limitation of HF response on tape, purchasing anything above 96kHz of an original analogue album is a waste of money.  Even finding something at 48k/24bit is going to sound as good as the original tape... the extra 48k sampling (for 96k product) is just leftover, in most cases.  
orpheus10
8,668 posts
 

How sweet it is! My favorite cut "Singing Winds and Crying Beasts" off of my all time favorite album, "Santana Abraxas" coming to me off of my computer play-list, from my latest LP down-load after new cartridge, plus NOS tubes installed in phono.


      https://www.youtube.com/watch?v=Xskk5q1DL6A


      https://www.youtube.com/watch?v=9wT1s96JIb0


It's like hearing this for the first time; although I have worn out numerous LP's that I played to death, I never heard it like I'm hearing it now. This music takes me back to the 70's, at my favorite club, the "Fontainebleau" (no, not that one, but another one with the same name)

The color was "hot pink", and ladies wore those stockings that glowed under black lights. When they walked through the club wearing these stockings, the lights from down low made it appear as though there were beautiful glowing legs walking through the club. This music intensifies my memories of those fantastic times.

Looking for a new pipe at a "head shop" was a lot of fun; there were these glowing posters, and always the smell of sweet incense, which was another item on the shopping list. Decisions, decisions; so many different sweet fragrances, which one to choose; jasmine, peach, or wild-flower?

This was the age of "Aquarius";


      https://www.youtube.com/watch?v=ajgeaOt_HTQ


Those were the most incredible times in my life, I hope you were there.


         
More to discover