Vintage DD turntables. Are we living dangerously?

For those of us who are not Dual cognoscenti, what is a Dual 701?  I guess we should assume it's DD.  Dual pioneered the coreless motor.  In fact, most coreless TT motors in use even up to today (Brinkmann) are naught but developments on the Dual motor.  Does the 701 contain such a coreless motor?

According to Vinyl Engine the Dual 701 is one of the rarer and nicest Dual decks out there.
Uses a " low torque direct drive motor"

Appears to have an enthusiastic following.

Good evening group.
i just inherited a JVC QL-10 with Lustre GST-801 from my uncle who passed away.
He bought it brand new in lates 70s.
I would say it hasn’t been turned on in the last 15 years.
i brought it home, cleaned it up and tried it.
it locked on 33.33 for about 5 minutes and then it sped all the way up to about 67.34 rpm.
33 and 45 run at that speed and then I can see it slows down and goes back up.
I opened it up and out of my league.
i can do some things, but this one looks scary.
is there a place where I can send it?
How much could I be looking at to have it fixed?
Thank you!

Pablo, You wrote, "I would say it hasn’t been turned on in the last 15 years."  There's one clue to a possible problem.  The electrolytic capacitors do not like to get old, but more than that they do not like to sit on a shelf with no voltage across them for 15 years.  At the very least, you should have brought up the voltage on your motor gradually, using a Variac.  This can allow the electrolytics to re-form and possibly save the bacon.  At this point, I doubt that a Variac would help, because the damage may already have been done.  I would suggest you unplug it and then have a pro replace all the electrolytics, just to begin with.  Other guys here do not like me to preach this particular gospel (replace old 'lytics with new after acquiring an aged DD turntable), but even most of them would have to agree that this should be done in your case where you know the history of disuse, before you blow up more unobtainable parts.  The 'lytics are dirt cheap. The integrated circuits needed to make the tt run correctly are very difficult to source, if not impossible.

Lewm, thank you for the quick response.
So every capacitor should be replaced on every board?
some of them are pretty tiny.
I see a few big ones by the power supply.
i have replaced caps in the past, but they were much bigger and it was on my amp.
When I took the TT-101 apart, it really scare me, everting seems so tight and there are wires everywhere! 
I’m used to seeing amps, which are much neater inside.