Vandersteens-- Removing M5-HPs for a Digital Xover?


Hi. Quick survey of people that have removed the M5-HP when using a processor/preamp that can do the Xover internally and how much of a sonic difference there was. I guess there is just something comforting about having the physical Xover in-line when the manual (I have Quatros) talks of all the driver damage that will occur if they are used without a Xover. I just upgraded my pre/pro to a Theta Casablanca that can do it internally. I would assume that there would be some kind of difference due to eliminating the parts inside the M5 and the electric change of having dissimilar metals between my interconnects and the pigtails of the M5s. I know that hearing it is the only proof but wanted to see others’ opinions. Thanks.

jwseitz

Showing 2 responses by audioconnection

(((Hi. Quick survey of people that have removed the M5-HP)))

This is like saying if i disconnect the Brakes in my car how many of you fellows will still have their family jewels left and are they still in decent working condition.

We have had many attempts to compare the M5 high pass units with the built ins yes the built ins can work but the Vandy Battery bias always comes out on top.

Perhaps this will help. If you can try and understand the unique design advantages.of speed  A High performance loudspeaker driver task where each driver has a purpose high mass drivers for bass a lighter faster driver for mid bass an even lighter faster Mid driver and finally a ultra light mass tweeter. The allows  proper tonal character at any given musical task. The high pass properly maintains the long waves out of the faster drivers. The full range speed this allows the whole system is brilliant when properly set up. All your doing by having the crossover improperly set is ruining the intended alignment and slowing the faster then normal drivers in these designs from operating as intended.

 Best JohnnyR

 

 

 

Greetings,

Please make sure that your Vandersteen High Pass Batteries are A up to date and B soldered in only by a professional, C make sure that you nailed the proper adjustments with the internal hi pass dip switches. As the series of dip switches to be set correctly is vital for performance.Please don’t just read the manual as many are wrong and in need of the following.

Play Track 27 Vandertones 1000 HZ voltmeter into left channels amp speakers binding post. Adjust Volt meter to AC Volts next adjust pre amp volume controls to see meter read 1 Volt AC then go to track 30 adjust the dip switches untill the meter reads .707 volts start all over again from track 27 until you nail it anything else is wrong. please don't forget to adjust both high passes to proper setting.

I would bet heavy once this is done you will easily hear its advantages.

Best JohnnyR