Copied from Enjoy the Music review.
Specifications
Type: Three-way vented-box system
Drivers: 1" decoupled double-dome aluminum high-frequency
6" woven Kevlar cone FST midrange
Three 6.5" paper/Kevlar ® cone bass
Frequency Response: 45Hz to 28k Hz (+/-3dB)
Within 2dB of reference response
Horizontal: Over 60°
Dispersion: Vertical over 10°
Sensitivity: 90dB/W/m
Harmonic Distortion <0.5% 110Hz-20kHz
Nominal impedance: 8 Ohm (minimum 3.2 Ohm)
Crossover Frequencies: 350Hz and 4kHz
Recommended Amplifier Power: 30 to 300 Watts into 8 Ohm
Dimensions: 42.8" x 14.4" x 14.3" (HxWxD)
Weight: 73.7 lbs.
Finishes: Rosenut, gloss black, and satin white
Grille Color: Black or Grey (with satin white finish only)
Price: $3999.99 per pair
30 to 300 wpc amplifier recommendation gives you a wide range of amps to work with. Your Mac at 200 wpc should be absolutely fine with the CM-10 S2. If one was pushing an amp to run at 200 wpc continuously then one is headed towards hearing loss or already suffers from it and might be better served by high efficiency Horn speakers or much larger floor standing speakers that can absorb that steady power input without blowing voice coils apart, especially on transients. Not to mention there’s little headroom left from the amp at peak rms so clipping will be destructive. At sane listening levels and average sized rooms the Mac / B&W combo should be more than satisfactory.
Specifications
Type: Three-way vented-box system
Drivers: 1" decoupled double-dome aluminum high-frequency
6" woven Kevlar cone FST midrange
Three 6.5" paper/Kevlar ® cone bass
Frequency Response: 45Hz to 28k Hz (+/-3dB)
Within 2dB of reference response
Horizontal: Over 60°
Dispersion: Vertical over 10°
Sensitivity: 90dB/W/m
Harmonic Distortion <0.5% 110Hz-20kHz
Nominal impedance: 8 Ohm (minimum 3.2 Ohm)
Crossover Frequencies: 350Hz and 4kHz
Recommended Amplifier Power: 30 to 300 Watts into 8 Ohm
Dimensions: 42.8" x 14.4" x 14.3" (HxWxD)
Weight: 73.7 lbs.
Finishes: Rosenut, gloss black, and satin white
Grille Color: Black or Grey (with satin white finish only)
Price: $3999.99 per pair
30 to 300 wpc amplifier recommendation gives you a wide range of amps to work with. Your Mac at 200 wpc should be absolutely fine with the CM-10 S2. If one was pushing an amp to run at 200 wpc continuously then one is headed towards hearing loss or already suffers from it and might be better served by high efficiency Horn speakers or much larger floor standing speakers that can absorb that steady power input without blowing voice coils apart, especially on transients. Not to mention there’s little headroom left from the amp at peak rms so clipping will be destructive. At sane listening levels and average sized rooms the Mac / B&W combo should be more than satisfactory.