upgrade your surround for 35.00


For years now i have had surround sound in all its forms, pro logic.dolby digital,and dts.I always thought i could set up the sound levels using my ears[wrong].I went to radio shack and bought a sound level meter[35.00]and the improvement in sound is tremendous.Everything is tied together between the speakers and the sound is a lot more realistic and detailed. If you have not used a sound level meter in your home theater,your cheating your self.I just held the meter at ear level in the sweetspot and adjusted all the channels including the subs.Some of the posters here, probably are smart enough to own a sound level meter, but for the rest of us get one now.
ears

Showing 2 responses by bigwood

I have owned and used the Radioshack SPL meter (Digital) for aproximately 1 1/2 years now and wouldnt trade it back for my original analog one. I only calibrate my system with my "AVIA" set-up disc or my "Ultimate DVD Platinum" set-up disc. These discs both have sustained test signals and not the "short test bursts" that my actual processor does so I can still get very accurate settings with a digital meter. I just sit in my actual listening spot with my meter in hand and take my actual readings where my head/ear levels are. I use my remote to adjust the individual channels (sub levels included). If I couldnt use sustained signals for testing then I probably would have stuck to my analog meter because it was very accurate. Another slight plus is that its just easier for me to read! I occasionally change my settings slightly for certain movies but not overly so. Some movies make excellent use of the full digital sound but most are lacking in one sense or the other,(ie; insufficient rear info, weak or too forward center channel dialogue, etc.). As far as meter settings go, Mikec in the above posts is correct. However I am always open to suggestions and if I found that my methods could be improved upon I would certainly give it a try! Later....
Actually, were not too far out of agreement Mikec. I also re-calibrate my levels whenever I change cables, components, speaker placement, or whatever else may have affected my settings. What I meant in my previous post is that with my digital meter when the initial signal is generated. the meter takes a second or two to "settle in" (for lack of a better term) to the actual reading being observed. An analog meter will shoot the needle actually faster to the setting than my digital meter takes to proccess then display the result! This is why I only use sustained test tones, I can run each tone for minutes as opposed to the few seconds each that my processor outputs (it has no manual setting). I hope that clears up any confusion on my original post. As far as sound pressure levels bouncing off my body, thats a good point, but the way I look at it my body's going to be there every time I'm listening anyway! (joke intended!) Anyway, for the 35 bucks or so for these meters you cant really go wrong when compared to calibrating by ear! Later...