two Channel equalizer recommendations

@solypsa. 
Thanks. I will take a look.

I think the K&T will do the trick. I like what I’m reading about it. Plus it has to have XLR and I like the fact that I can use my own power cord. For that price may as well give it a shot. Thanks again for the suggestion. 

@rauliruegas 

interesting. That first link you posted looks almost identical to the DBX which I was also considering. 

https://www.idjnow.com/dbx-dbx231sv-equalizer.html?gclid=EAIaIQobChMIgrSJot7i7wIVlOCzCh2UsQr3EAAYAyA...

Thanks. I will take a closer look at both 

amen

I’m not new to the game guys. I do understand the pros and cons of using an EQ. While I do appreciate the advice, lets try to stick with the topic. I’m not asking if it’s ok to use one. I am going to use one in this application. Just was asking for a good recommendation. Respectfully I’m Not trying to be dismissive but I would rather not go down the rat hole of should I or shouldn’t I.
Kindest

@rauliruegas 

So after looking at a few recommendations I have decided on the Klark Teknik n360. 
@solypsa 

I also looked at the Cranesong. Sounds very impressive. However for the system I’m connecting it to I don’t want to make that type of an investment. Like I said the only sliders I will use will be between 500 Hz - 2k range once I figure out which couple I will use and they will only be raised a tad bit. Everything else will be flat. For this system the Klark Teknik should be all I need. 
Thanks all for the recommendations and also the comments. I will report back and let you know my experience. 

I purchased the Klark Teknik 360N and it sounds great. Not so sure why people throw shade on using an EQ. I guess they are easy for some people to use them in an extreme manor. I’m adjusting freqs from 500Hz to 1Kh and I’m only moving them oh so slightly to give me the desired effect. I guess if I did the ole V or smiley face maybe I could see degradation in SQ but that’s not the case here. I hear no distortion or loss of SQ actually quite the opposite. 

The gear it’s connected to:It’s inline with a custom made tube amp. This amp has only one input and a volume control. It’s being fed line level inputs by a passive line level switching component from the two sources I have connected to it. 

Without going into a full out review etc I will just say it sounds fantastic! 
Personally I don’t see a problem with using one as long as you don’t go nuts with it. I’m definitely enjoying this little system much better that’s for sure. I guess mileage may vary depending on what gear your using it with but I think as long as the electronics in the EQ is as good or better than in your pre-amp there should be no loss of SQ. 
The KT EQ has excellent build quality. It’s 32 band so you can get quite granular with the adjustments. A little goes  along way so I did not have to move the sliders very much at all. If you just glanced at it you may not even know the little hump was there in the middle. So for me in this application it made the difference. 
@rauliruegas 

Much thanks again. This is exactly what I needed. Great suggestion on the piece.  
-Keith