AFAIK, resilient channel is for isolating noise, not for improving room acoustics.That is generally correct, although at ASC we do use resilient channel in conjunction with constrained layer damping to allow walls and ceilings to act as giant bass absorbers. The ceiling is often a prime candidate as it is the largest surface in the room not obstructed with doors and windows.
Two channel and home theater room under construction
Some of you have followed my threads about getting a new room in which to listen. Well, it's underway. I've got to work with the parameters of the space -- 26 x 15 x 8 ft ceilings -- but I was able to accommodate some suggestions. Two photos at bottom of system page:https://systems.audiogon.com/systems/9064/edit
There will be 5 dedicated lines. Three at the end of the room where my audio gear will be, and two more at different locations in the room just in case the gear moves or other things need to be plugged in further away. There is one line along the sidewall in case I can get my gear away from my speaker's front wall. The lines are using 10 awg romex. Hard to fulfill some of the other electrical desiderata because we are not using a special electrician and it was just too hard to do too much. I did get a sheet of requirements to them (regarding breakers, silver paste, etc. Some was done.)
The drywall is all 5/8". The ceiling has insulation, a layer of drywall, an RC channel, and a second layer of drywall below it.
It looks like the room will have to also contain a TV and an AVR, but I'll mount the TV flush on the wall behind the speakers and have something to cover it with. The electronics for the TV will be on a separate line.
For the short run, because we have pets, we're going with LVF flooring and area rugs over concrete. The LVF will hopefully have something under it -- cork might be good. In the short run, some area rugs. In the longer run, a wall to wall carpet, not too thick.
It's very hard to think through other things until I can get set up and listen, but hopefully the fundamentals are being put in place. It's a room not dedicated to audio, but it will be friendlier than my current space with 6 foot ceilings.
There will be 5 dedicated lines. Three at the end of the room where my audio gear will be, and two more at different locations in the room just in case the gear moves or other things need to be plugged in further away. There is one line along the sidewall in case I can get my gear away from my speaker's front wall. The lines are using 10 awg romex. Hard to fulfill some of the other electrical desiderata because we are not using a special electrician and it was just too hard to do too much. I did get a sheet of requirements to them (regarding breakers, silver paste, etc. Some was done.)
The drywall is all 5/8". The ceiling has insulation, a layer of drywall, an RC channel, and a second layer of drywall below it.
It looks like the room will have to also contain a TV and an AVR, but I'll mount the TV flush on the wall behind the speakers and have something to cover it with. The electronics for the TV will be on a separate line.
For the short run, because we have pets, we're going with LVF flooring and area rugs over concrete. The LVF will hopefully have something under it -- cork might be good. In the short run, some area rugs. In the longer run, a wall to wall carpet, not too thick.
It's very hard to think through other things until I can get set up and listen, but hopefully the fundamentals are being put in place. It's a room not dedicated to audio, but it will be friendlier than my current space with 6 foot ceilings.