Turntables


I am kicking the idea of trying out vinyl. It’s been a long time since I had a turntable and it took a lot of thought whether I can deal with what always seemed like the snap, crackle & pops of an album. Anyway, I’ve decided to take a plunge after all the buzz how awesome it is. Of course before I make any final decisions, I always turn to the Audiogon community for their expert thoughts, opinions and education. I’m also looking for suggestions for a nice affordable table with tone arm and cartridge. Being the fact this is new to me and I may hate it, I’m looking for suggestions on the best affordable set up I can do for a new or used in the price range of $1000/$1500. I’m sure I can get a better bang for the buck going used. I just don’t know anything about these animals. My system is older but I still enjoy it which consist of a Mark Levinson 23.5 amp, Proceed AVP 2+6 used for 2 channel audio, Audio Acoustics model 9 speakers, Ayre DAC for digital with Transparent Audio Ultra mm2 cables. Any input is greatly appreciated!
luvrockin

Showing 1 response by andrei_nz

When you get a TT you are not just getting a TT.  You are getting a lot of baggage:  [i] Cartridges; [ii] Phonostages; [iii] Another cable or two (and you really do have to get a quality cable as the signal is about a 1000th of a line stage signal); Tricky setup including [iv] think minimising vibration, [v] getting a 100% level platform, [vi] setting azimuth, [vi] setting VTA, [vii] setting overhang, [viii] setting tracking force;  [ix] Expensive LPs, [x] Vinyl cleaning, [xi] Stylus cleaning. 

I know all about it I have 3 TTS.  But if you want to give it a go then a Technics 1200G (or that family) is the way to go.   In one shot you are getting a superlative TT, and your setup issues will be far less.  Another truly fabulous advantage is just dropping the needle.  Almost impossible to screw up.