2. analog
  3. 1158220304

Tuntable not working with wood floors..Help

Moved into a new (old) house, with wood floors and it is giving me a huge headache. I have my AR Turntable sitting on top of my rack, and it is absolutely unplayable. You can not even tip toe through the room with out the needle bouncing out of control. I placed a bike tube and a piece of glass underneath it, and it helped, but its still not playable. Here's what I need to know. 1) Would a new table help? The AR is set up so the platter and the arm float on the same suspension (which appears to be very loose), would a TT with a different design help/solve my problem. 2) If not the table, what can I do to get this thing to work? I am in college so $ is very slim (I am talking Ramen and Keystone slim). I don't think my landlord would be happy about mounting it on the wall, but I may take that chance if it comes to it. All advise is much appreciated!
azavguys
rbirke
144 posts
 
Such complicated solutions!

Go to a place that sells marble and granite countertops, and get a slab that they cut out for a sink in a kitchen. Get a nice thick one -- 1.5 or 2 inches. If where you are is anywhere like here (Portland Oregon) you'll be able to get a nice piece for less than $20.

Plop that baby on a low sturdy table and put your tt on top of that. It's almost as good as a concrete floor.

Then, once you have the $, get a Mana support. They work wonders for Linn LP-12's and the AR is quite similar.
dgarretson
2,598 posts
 
I have old sprung floors in my house. I don't care how much you mass load the joists from the top (I have used up to 600lbs.), you cannot eliminate vibration passed from feet or from the main speakers into the TT. Corner placement can reduce vibration significantly. Any adverse effects from standing waves in the corner is minimal in comparison to the improvement gained from a solid footing. If you have access to the basement below, shore up the joists with 4x4s and jacks.
azavguys OP
1 posts
 
Thanks to everyone for all the ideas. After realizing that the room I am in was added on, and one of my walls is concrete, I decided to mount the table on the wall. Got some brackets, 2 pieces of 5/8" MDF and some foam to place between them from Home Depot for under $30. Had the shelf installed in under an hour, placed the turntable on top, started playing, and its absolutely fantastic!! You can jump rope in front of the table and the needle doesn't move an inch. I could not be happier with this set up, I know I lucked out. Thanks again for all the advise!
audiofeil
4,011 posts
 
As the title of an early Fleetwood Mac album says, "Then Play On".
Congrats.
ptmconsulting
1,000 posts
 
You took the words right out of my moutn - try a wall mount, but make sure its a load bearing wall for best results.

The other option, which worked fairly well for me in the past, is to put the TT on a maple butcher block and put rollerblocks under that. Worked better than any other type of suspension that I tried. Inner tubes was the worst IMO.

Glad you found a solution that works for you.

Enjoy,
Bob
More to discover