Tube Preamp for Solid State Monoblocks?


Hi Guys/Girls of the Hi-fi World

I just acquired the Audio Zone D2 Monoblocks rated at 200wpc and of the Class D variety.

I have been hearing great things about a tube pre and solid state power amp combo and I think this would suit me well.

Any suggestions for a good tube pre (preferably under $700 used or new)?

Also, I already have a little dot MK III, would this be a good match?

Any input is greatly appreciated!
everettjsj2
Can somebody tell me if i can use the Copland CTA402 integrated as a preamp to match it up with the monoblocks?
No, you can't.

First, it appears to not have preamp output jacks. It just has tape output (and input) jacks, which presumably are not controlled by the volume control.

Second, most or all tube integrateds (or more precisely, integrated amplifiers that have tube power stages and output transformers) should not be used as preamps, because operating the power amplifier section without a speaker load can cause damage.

Regards,
-- Al
A1, thank you very much. I have been waiting for a while to get an answer after posting the same question on other threads. This helps.
Iam also very interested in tube pre-amp. Unable to find a local dealer with a wide variety. Has any one tried Mac tube pre-amps with classe cam-400
A nice used Conrad Johnson PV-10, PV-11 or PV12 might do the trick for you. I had a PV-11 for several years with a SS power amp. Lovely combo, IMHO.